Electronics Forum | Sat Feb 17 18:17:36 EST 2024 | jeautom_32
Anyone have use for 3230, 3240, 3450 UIC nozzles?
Electronics Forum | Mon Aug 21 11:28:30 EDT 2000 | James
Question: Do you run your pallets hot or cold thru the wave? I ask this because if you run your pallets cold the board will never preheat to the correct temp. thus, your flux won't activate properly. James
Electronics Forum | Fri Jan 08 02:27:00 EST 1999 | Kwang-Seong Choi
HI! I am a package engineer in Korea. I have some reasons to desolder excessive solder at the lead of TSOP and TSOJ after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. Does anyone know the
Electronics Forum | Mon Jun 12 10:34:06 EDT 2006 | cuculi54986@yahoo.com
My brother-in-law is a DDS and I trust him. We had some problems with solder voids in the past, and he was invaluable. He'd drill them out and fill them with SAC3240X+.
Electronics Forum | Mon Jun 29 07:17:25 EDT 2015 | donlockard
Seho maxi wave 3240 should be considered as well. Invented full tunnel nitrogen systems that have lower operating costs and provide yields unlike what can be achieved by air wave systems.
Electronics Forum | Fri Jan 08 15:02:38 EST 1999 | Dave F
| HI! I am a package engineer in Korea. I have some reasons | to desolder excessive solder at the lead of TSOP and TSOJ | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | Does anyone
Electronics Forum | Fri Jan 08 19:47:55 EST 1999 | Kwang-Seong Choi
| | HI! I am a package engineer in Korea. I have some reasons | | to desolder excessive solder at the lead of TSOP and TSOJ | | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. | | Does
Electronics Forum | Sun Jan 10 08:44:32 EST 1999 | Dave F
| | | HI! I am a package engineer in Korea. I have some reasons | | | to desolder excessive solder at the lead of TSOP and TSOJ | | | after removing them from the board. The way with solder wick is too time-consuming and depends on the operator. |
Electronics Forum | Tue Aug 25 21:01:45 EDT 1998 | Peter
We use an Intermec 3240 Thermal transfer printer and print on polyimid label material that survives the reflow and wave solder (top side only) process without turning black. Labels run around 3-4 cents per depending on the size (We found Imtec label
Electronics Forum | Fri Aug 28 18:57:49 EDT 1998 | Mike Cleary
Selecting the correct label solution for SMT labeling is a science. Our company is a supplier of electronic identification products. Please let me know if you have questions regarding materials, printers, etc. I have been in this industry for over
| 1 |
winsouce.jpg)
