Electronics Forum | Thu Apr 19 01:50:49 EDT 2018 | leeg
Whats the best way to joint a broken conveyor drive belt? Ive tried a rubber glue which lasts for a short time and tried touching both sides to an iron tip and then holding together, again with poor results.
Electronics Forum | Thu Apr 19 06:11:07 EDT 2018 | robl
Using a hot blade and clamps: https://www.youtube.com/watch?v=aI-IWfmnLaA
Electronics Forum | Thu Mar 04 12:49:56 EST 2004 | haviland
Good morning. We have available several decline and several flat bed belt style exit conveyors, including a couple w/ cool down fans above the belt, e.g., a Kanetic48" OAL w/ 18" wide belt plus (8) fans priced at $1,000.00 FOB IL.
Electronics Forum | Thu Jul 22 07:30:21 EDT 2010 | nitronica1
does anyone know where I can get replacement conveyor/drive belts for a Fuji/astro pcb 0.5m conveyor? pref from the UK or europe the length of the belts are approx 630mm and 6mm wide, flat with bumps on bottom side
Electronics Forum | Wed Jul 13 13:23:34 EDT 2011 | kkay
We have multuiple pcb transport conveyors that use the 10mm wide flat green blets on either edge. Does anyone know of a kit to purchase where we could make our own or a company that supplies different sizes? Thanks
Electronics Forum | Mon Aug 21 11:15:31 EDT 2006 | aj
All, We have a conveyor that uses an o-ring belt , this belt breaks quite regular which causes a hassle for the SMD Ops. The stuff we use is from Radionics,its 3mm also. Anybody recommend a good belt or procedure for joining them together( we curr
Electronics Forum | Fri May 05 03:38:02 EDT 2023 | ttheis
I am looking for some parts to repair a dyna-pace 1 meter conveyor if anyone has a scrap unit laying around. We just need the sheet metal edge strip as shown in the attached photo. Also looking for width adjust handles and a source for the 10mm wide
Electronics Forum | Sat Aug 26 10:28:05 EDT 2006 | Ola
Hi, this is not a solution for your o-ring "belt" problem but a guideline for the future on an o-ring "belt" (wrong word as it is Not a belt) conveyor. These crazy O-rings have a small radius which makes it somtetimes hard to do a conveyor width adju
Electronics Forum | Fri Nov 30 00:51:10 EST 2007 | vinitverma
Here are the differences (Eclipse vs Eclipse II) Optimum Speed: 5000 vs 6500cph Feeder Positions (8mm) : 80 vs 94 PCB Loading Time : 4s vs 5.3s PCB Thickness : 0.6-3mm vs 0.5-4mm Max Component Size : 32mm vs 45mm (optional camera possible on Eclipse
Electronics Forum | Thu Jun 13 09:39:43 EDT 2019 | don_julio
Problem is I don't have a mesh belt (lesson learned). Our conveyor is pins. If I laid some scrap pcb's spanning the conveyor pins on the long dimension of the board, I'm confident it would sag. We get a bit of sag today in our 1.6mm thick boards whi
