Electronics Forum | Thu Oct 02 21:00:26 EDT 2003 | davef
Who says the chlorine comes from your tap water? Our PTOW dumps boat loads of chlorine into our water periodically. Sometimes it's so bad you can smell it. We doubt that it is the source of your problem. This chlorine will volitize very quickly,
Electronics Forum | Wed Apr 02 14:47:59 EST 2003 | slthomas
Operating Parameters X Direction (left to right) 18.0 inches Y Direction (front to back) 18.0 inches Z Direction (up and down) 1.5 inches Operating Speeds Slew speed and point-to-point is 20 in./sec. Eight increments of speed control from 0.01 in./
Electronics Forum | Mon May 20 10:49:12 EDT 2002 | geoff_goring
Are we saying then that IMC can occur at the solder / Cu pad join on the PCB when finished assembled? In our case we are being told that this process is starting before assembly. Is it fundamentally the same thing. i.e. will the Tin diffuse with th
Electronics Forum | Fri Oct 04 01:18:27 EDT 2002 | sarge
1.5. Width >= 4-5 Particle Diameters. Use the smallest opening to determine this. Using dimension of the smallest aperture width, you should be able to fit minimum of 4-5 solder balls side by side into the opening. For 0201 design, -400 mesh (type
Electronics Forum | Mon Apr 07 12:21:02 EDT 2003 | davef
Russ is correct. A 5 thou thick stencil should give good release. Here's how you run through it: * You want at least 5 solder particles across the smallest aperture. So in your case, 8 thou wide, which equals to 0.20mm gives us 0.20/5=40 microns.
Electronics Forum | Tue Aug 31 12:42:45 EDT 1999 | Charles Barker
****************************************** ***************** HELP! *************** ****************************************** We are having a special ceramic smt board made. The boards are 16-up arrays that have smt pads on both sides. Only thre
Electronics Forum | Wed Aug 24 16:30:11 EDT 2016 | shawn_halo_1
I have a 1oz Flex PCB (FPC) that has 2 0.4mm pitch connectors that need to be SMTd and 9 4.5x1.0mm pads that have conductive rubber contacts that are press fitted onto the FPC. The FPC has a one time bend radius of 15.5mm. Image is attached that show
Electronics Forum | Mon Nov 06 02:56:11 EST 2006 | Loco
*We've tried the WSP80s for leadfree, also SAC. Problem with these was when they are not being used, they keep their temp and oxidate like hell. Second problem is as Russ states, the sensor is not in the tip, therefore to get the same heat in the t
Electronics Forum | Sun Aug 13 12:16:02 EDT 2000 | Arturo
I think you are talking about Infra Red motion detectors.Most of them are 4.5V. You can use a voltage regulator 7805 IC(5VDC Output) after your 12 or 9VDC supply. In case your detector requires a different supply voltage simply choose a 78XX(XX=Volt
Electronics Forum | Tue Jun 17 01:38:01 EDT 2003 | Dreamsniper
Hey fmonnette, What's wrong if I have a dry cabinet and baked all my components under 1-3%RH or say 5%RH regardless of their MS Level, whether they r level 4, 5, 5a, 6 etc.... What will be my problems in doing that process? just for curiosity, th
