Electronics Forum | Wed Apr 28 14:58:39 EDT 2004 | davef
Solder ball acceptability: IPC-A-610, 6.5.3.1 & 12.4.10
Electronics Forum | Tue Feb 09 12:47:56 EST 2010 | swag
Refer to the thread started by Deni on 2/4/10. Your problem is similar.
Electronics Forum | Sun Oct 17 09:25:46 EDT 2004 | raj_nz
CARD 586 DBIOS VERSION 4.10A.01 SEIKO EPSOM CORP 1997 KM5-M4254-1XX VER 1.00
Electronics Forum | Fri Jun 29 14:13:05 EDT 2001 | markhoch
Just a quick thought on solder balls "or beads" caused when using NC paste. I found a spec (12.4.10 in IPC-A-610C) that says solder beads are acceptable if they are entrapped in NC flux residue and can not be dislodged in the normal service environme
Electronics Forum | Wed Jul 06 15:29:01 EDT 2022 | glasscake
Also I should mention, I've ditched the formulas for getting the "optimal" solder amount after being bit by them once. Now I just design a PCB with 4-10 spots for the connector then order a stencil with a range of aperture sizes. Figure out what give
Electronics Forum | Wed Jan 31 17:45:37 EST 2001 | dason_c
Hi! William, please check the new IPC-A-610 Rev C, para 12.4.10 for the soldeirng anomalies. Most of them may consider as process indicator and not the defect. The most common method to elimate the solder ball is to reduce the solder volume by red
Electronics Forum | Mon Jul 16 15:49:33 EDT 2001 | Steve
The solder balls you are talking about are caused by too much paste. Reduce the size of the stencil aperatures. Concerning removing the solder balls, the first thing you need to ask yourself is, do I need to remove them. IPC-610, 12.4.10 states, "Ac
Electronics Forum | Thu Feb 07 11:59:48 EST 2002 | Ron Costa
When double sided BGA's are used on an .062 FR4 10 layer board should via's be plugged and tented? The CACHE chips being used are PBGA's 1.27mm pitch. The pad size is .030 and the finished via dia. is .010. This is a dogbone type pad and via design.
Electronics Forum | Tue Mar 17 07:32:10 EDT 2009 | davef
Solder ball acceptance: IPC-A-610, 6.5.3.1 & 12.4.10. Solder balls: 5 ball system: * No more than 5 balls per square inch (100mm2) allowed * Solder balls can not be greater than 5 mil (0.005in) (100um) * Solder balls cannot be less than 5 mil (100um)
Electronics Forum | Fri Sep 08 21:49:24 EDT 2017 | sbar5781
Hello, I have a few PCB boards i am trying to be manufactured that are miniaturized medical devices. Thus they require IPC Class 3 Specs. However as miniature devices they have limited space, including a 0.4mm pitch BGA socket, which currently has
