Electronics Forum | Thu Jul 27 11:27:39 EDT 2006 | gregcr
Hi All, Wondering if anyone is using this Autosplice CC-112 Pin inserter. We have one here and I am wondering if there is offline software or a serial communication spec that is used to load programs in from a PC. We can make changes on the unit i
Electronics Forum | Tue Apr 19 10:19:28 EDT 2011 | leemeyer
We currently have a job that uses press fit solderless pins. The pins are custom and only supplied in bulk packaging. I am looking for a machine that can orient the pins and present them to my insertion machine. Of course i need the pin to be present
Electronics Forum | Tue Aug 28 23:53:31 EDT 2007 | crashoveride
dedicated fixture works best if the board is very much populated. But if the parts to be inserted are less than 300components, adjustable fixtures may be used. But the secret of good insertion is a precisely measured tooling pin to prevent the boards
Electronics Forum | Thu May 17 07:36:40 EDT 2001 | Bob Willis
Here is a copy of a draft document on PIHR Inspection I have jotted down on a flight to Scotland yesterday, any comments suggestions etc ? I have already most of the photos for the standard but as you know there is nothing in the IPC document it just
Electronics Forum | Fri Aug 09 03:59:35 EDT 2019 | sssamw
Did you check the pin location accuracy before placement? I mean if possible pin was hit or misaligned a little before placement, so the pin cannot inserted in hole then bent. And maybe you need contact your component supplier to study together.
Electronics Forum | Fri May 26 14:22:27 EDT 2000 | JAX
GP, What are some of the details. type?(mictor) guide pins?(yes/no) component demensions? Machine inserted? Force of insertion?
Electronics Forum | Fri Nov 21 13:14:21 EST 2003 | pjc
Panasonic is another supplier of automatic radial lead insertion machines. Go to: http://www.panasonicfa.com/cgi-bin/product.cgi?prodline=electronics%20assembly&category=Pin%20Through-Hole∏id=rh5 www.panasonicfa.com
Electronics Forum | Fri Jul 24 16:37:47 EDT 2015 | cnotebaert
to my knowledge it will always be manual insertion,, if you mean reflow, not insertion, I always apply solder to one side, reflow, then apply tacky flux pre print to the already soldered pins, print op side, assemble part then send through placement
Electronics Forum | Fri Apr 30 07:29:02 EDT 2021 | dilogic
Status output is pin 2. On pneumatic feeders it only shows if the feeder is inserted, on electric feeders it doubles as feeder insertion and goes off if the tape is exhausted or feeder is jammed
Electronics Forum | Fri Nov 14 17:15:54 EST 2014 | tombstonesmt
Are you experiencing the solder balls on the opposite side of connector insertion or same side? If it's the same side as connector insertion how many strokes are you using at? We've experienced a few issues with pin in paste, everything points back
