Electronics Forum | Wed Sep 10 10:13:37 EDT 2003 | qp1
Dear Please the name and the conditions of this swap program Thanks
Electronics Forum | Thu Jan 15 13:06:42 EST 2009 | stiva
Thnaks Pitbull That worked
Electronics Forum | Wed Sep 10 06:31:32 EDT 2003 | qp1
Dear We have several 4796HSP in production We often have problems with the driver card D2332, S-ver1.32 Wver0.11 For replacement they are quite expensive Can someone tell me how to avoid this problem or how to repair these cards Or is this a known p
Electronics Forum | Thu Nov 14 14:16:18 EST 2002 | ernman
In a low vol/high mix which would be the best. 3 Assembleon Topaz Xi's or 1 Universal 4796HSP & GSM
Electronics Forum | Tue Sep 16 10:06:51 EDT 2003 | qp1
Thanks very much for all your advises We certainly are a step forward Please if yoiu have some more advises ,send them to me
Electronics Forum | Mon Feb 21 13:21:57 EST 2005 | O.Tarango
Firstable, thanks for all your comments,sorry if my question was too un detailed, I really need your help on this, actually we are using a 4796 HSP in our SMT process most of the incidences of mis aligned component are on two 0420's capacitors Rega
Electronics Forum | Mon Jan 12 23:25:27 EST 2009 | sachu_70
Did you try explaining the problem to your machine manufacturer for direct assistance? Perhaps your machine brochure would indicate a 24hrs helpline service, or any contact no.
Electronics Forum | Wed Sep 20 14:20:44 EDT 2006 | Rafael
Dear all, Does anyone know how can I duplicate feeders in the same carriage of the HSP? The issue is: 2 sequenced feeders (101 and 102, for example) with the same part numbers. I need that, when feeder 101 ends, the machine should pick the componen
Electronics Forum | Fri Oct 24 09:03:34 EDT 2003 | Bill
Has anybody had to replace the rear LCD monitor on a 4796 HSP chipshooter? Universal is quoting 10k (!) for a new one as they are hard to locate. Patlite (the LCD manufacturer) has discontinued the unit GSC-1000ARS-W and is unable to help. If an
Electronics Forum | Thu Jun 16 18:23:52 EDT 2005 | Jason Fullerton
Check your pick height/depth. Check your feeder alignment. We run 0402s at 0.10 tact. We run 0201s at 0.20 tact, but only because I don't require any more throughput - I have placed them at 0.10 during testing, and there are companies that place th
