Electronics Forum | Thu Sep 21 09:20:13 EDT 2000 | Ron H
What is the phone number or web address of Circuit Repair Corp?
Electronics Forum | Thu Sep 21 12:41:35 EDT 2000 | jackofalltrades
Cicuit Repair Corporation 45 research Dr. Havenhill, MA 01832 Phone# 978-374-5000
Electronics Forum | Sat Aug 22 12:40:04 EDT 2015 | mdibertf
DEVICE=D:AOIMCINTCAMINT.SYS /PCI /CD:AOIMCINTC768X484.TXT /6
Electronics Forum | Sun Sep 17 22:50:20 EDT 2000 | Sartor
I am looking for a solution for gold finger cleaning and repairing.Can anyone recommend good solution(s)?Also,can anyone recommend a good flux paste source(s)?Thanks.
Electronics Forum | Wed Sep 20 16:01:05 EDT 2000 | jackofalltrades
We get solutions from Circuit Repair Corp. PS-054 Solder Strip PS-044 Electroclean PS-034 Nickel PS-024 Gold
Electronics Forum | Fri Jun 26 05:18:28 EDT 2009 | rway
Contact Elect-Test Fixtures, 484-921-5350. They build our test fixtures and we get most of our fixture supplies from them. They have the standard 1" and 1.5" hold-down pins. They may have other lengths as well. Tell them Reese sent you.
Electronics Forum | Sat Aug 22 12:38:15 EDT 2015 | mdibertf
Do you still have the HD problem? depending on the cameras you have this matvary abit but try this line and make sure you have the path shown and with drivers DEVICE=D:AOIMCINTCAMINT.SYS /PCI /CD:AOIMCINTC768X484.TXT /6 regards Marcos D
Electronics Forum | Thu Feb 24 06:09:26 EST 2000 | Robert Hutton-Squire
Hi, - any suggestions welcome... I have a 484 pin ALTERA fineline BGA - ball pitch 1mm (40) - ball size 0.48mm (18.9) What would you recommend for... 1. Surface pad size for the balls of this BGA device? 2. Stencil thickness/type and hole a
Electronics Forum | Wed Nov 15 16:14:02 EST 2000 | Scott Welle
We are having non-wet (head in pillow) problems with Altera 484's similar to the problems discussed on 10/27 timeframe. Need contacts to those people having similar problems. Will those who had problems with Motorola 357 (ref Chris and Glenn on 10/
Electronics Forum | Thu Feb 24 06:09:26 EST 2000 | Robert Hutton-Squire
Hi, - any suggestions welcome... I have a 484 pin ALTERA fineline BGA - ball pitch 1mm (40) - ball size 0.48mm (18.9) What would you recommend for... 1. Surface pad size for the balls of this BGA device? 2. Stencil thickness/type and hole a
.png)
