Electronics Forum | Mon Nov 06 10:11:49 EST 2006 | slthomas
I found the following link here in the fine SMTnet archives: http://www.tkb-4u.com/code/smdcode/indexsmdcode.php
Electronics Forum | Sat Nov 04 06:15:05 EST 2006 | James.li
I would like to know if it exist a croos reference book for marking code on smt device? I'm fixing a unit now and try to know what are the following devices: The look like mosfet and are mark like that "A2sKG",there are a horizontal line on top of "s
Electronics Forum | Wed Mar 22 05:40:52 EST 2000 | tabbakh
I would like to know the reference of 2 surface mounted device 1)marking D05 SOT143 2)marking R2 D SOT23 Thank you very much
Electronics Forum | Wed Apr 26 11:58:32 EDT 2017 | bobpan
Mod code 7 is a placement delay.....changing it will slow your entire program down. If you just want to slow it down for 1 placement.....you have to insert a mod code change in the sequence steps....this is easily done in central controller. Good L
Electronics Forum | Wed Sep 04 12:55:51 EDT 2019 | dwl
Sounds like its just rejecting parts. Either the length and width of the component is wrong or the tolerance is set too tight. I don't remember the function codes to edit the tolerance but I left them at 30% (the max) and never had any problems with
Electronics Forum | Wed Sep 04 14:12:26 EDT 2019 | bobpan
It sounds like the vac-verify is not working. There is a command on the hht to turn it off. When turning off your hht will show either 'idle' or enter command' without the V showing anymore. Maybe try the cntrl and vacuum or shift and vacuum. If its
Electronics Forum | Thu Dec 24 12:43:18 EST 2020 | marcelorotofrance
Hi Bob. When I initialize the system, all functions appears. In "Utilities/Initialize System Comm" option too. I have to confirm yet, but this problem appears to not happen in all programs. The red error message shows when I launch the program. My su
Electronics Forum | Wed Sep 04 13:58:36 EDT 2019 | smrsteve
Hello Bobpan, Thanks for the response. 1. Function 30 gives me a consistent 182-185, even after nozzle changes. I can vary this by changing mod code 15 and I have been advised to aim for 90-110, but it doesn't seem to make any difference so I've go
Electronics Forum | Wed Sep 04 09:47:41 EDT 2019 | smrsteve
Hello All, I've just bought a Quad 4c pick & place machine. It's so close to actually building boards, but just doesn't quite get there. I was wondering if there's somebody out there with experience of these machines that might be able to help...?
Electronics Forum | Wed Sep 14 23:16:58 EDT 2005 | Author
If it is necessary to define the type SMD semiconductors on its code of the marking (marking code, top mark) - visit the site (no www!)http://users.zebratelecom.ru/~smd_marking The having read article "rules of the marking" you get the full pres
winsouce.jpg)