Electronics Forum | Thu Mar 15 17:34:38 EST 2001 | rentreo
I place 0302's on my Quad 4c's all the time. Use a repeat pick-up just like a waffle tray part but make sure the z height is perfect on your pick-up or you will bounce the other parts out of their pockets. Also change your mod code to only try once o
Electronics Forum | Tue Oct 02 16:22:28 EDT 2012 | mmjm_1099
Give this a shot.. http://www.marsport.org.uk/smd/mainframe.htm
Electronics Forum | Fri Aug 30 21:54:14 EDT 2013 | nophsem
Well, the error occurs with Mod Code 56 (dispenser enable). Head # 1 has installed this accessory, but we use it very little and it wasn't this time. I probed setting 0,1,2 and 3. I downloaded Mod Codes from controller to assembler, then the error b
Electronics Forum | Tue Oct 01 11:56:57 EDT 2013 | bobpan
I would try the following: 1. Back up your mod codes or make sure they are up to date. 2. Turn off the machine and slide a business card between the battery and the clip located on the EPCU card in the front card rack. 3. Download back in your mod co
Electronics Forum | Fri Aug 30 10:35:54 EDT 2013 | nophsem
Data base Utilities --> Download MOD Codes to assembler) and the motor error # 5 appeared instantly in the handheld.
Electronics Forum | Fri Sep 06 11:07:27 EDT 2013 | bobpan
Use the hht and do a function 6.....this will tell you the version of firmware that the machine is running and then you will know which mod code list to go from. good luck
Electronics Forum | Fri Sep 06 11:37:43 EDT 2013 | bobpan
I dont have a list for anything that old. The oldest i have is version 2.10. Check to see if the mod code list that you have says what version it is.....usually its on the top of the document
Electronics Forum | Fri Sep 28 17:39:44 EDT 2012 | hishamuddinjohari
Hi, I cannot find the following SMD semiconductor marking code 'H890' somebody help me
Electronics Forum | Mon Sep 30 15:26:48 EDT 2013 | leemeyer
I have been using Quad 4C's for 15 years and have never come across this error. Everything initializes OK but when I start a program through Central Controller I get an "OUT OF MEMORY" error. I have flushed the Mod codes and re-entered them and have
Electronics Forum | Mon Nov 21 14:22:22 EST 2011 | mosborne1
Tim, The main controller card has a battery on it. Power down the machine and disconnect power. Stick a credit card between the battery and the clip. Hold for at least 60 seconds. Then power back up the machine. Make sure to have yourmod codes writ