Electronics Forum | Tue Jan 14 11:39:51 EST 2020 | avillaro2020
Thanks Robl. I’ve contacted samtec followed their advice but ended up empty handed. Originally my stencil thickness is 6 mils, samtec stressed the need for the paste and charge to have good contact but this is challenged by the inherent charge non-co
Electronics Forum | Tue Jan 14 11:53:44 EST 2020 | avillaro2020
Hi Phil, thanks. I am successful using the same connector on small thinner boards 2-2.5kg) i cant make it work, tried all kinds of profiles with vapour phase but to no avail. Yes you read it right 4.3-6.3mm pcb thickness and 2-2.5Kg. And it is 44 lay
Electronics Forum | Mon Jan 13 17:39:49 EST 2020 | avillaro2020
Hi, I need help on how to address the solder wicking on the samtec searay connector after reflow resulting to open solder joints on thick and thermal heavy PCB (4.4mm and 6.3mm). I increased my solder paste thickness to 8 mils, the connector is manua
Electronics Forum | Sat Jul 10 01:45:45 EDT 1999 | Scott
| Do you have experience with reflow process of a straddle mount connector on a 1.6 mm PCB ? | Connector have more than 200 pins | | What is the process ? | | Thanks | Depends on the connector... For connectors that have pre-applied solder such as
Electronics Forum | Thu Jul 08 03:33:33 EDT 1999 | Ron Lahat
Do you have experience with reflow process of a straddle mount connector on a 1.6 mm PCB ? Connector have more than 200 pins What is the process ? Thanks
Electronics Forum | Thu Jul 08 13:21:18 EDT 1999 | Bob Barr
Ron, We use 100 pin straddle mount connectors on some of our 1.6mm boards (up to eight per board.) They come to us from the vendor with a bead of solder on the somewhat 'J' shaped leads. Our process is as follows: Mount connector to board with hard
Electronics Forum | Tue Mar 13 17:29:18 EDT 2007 | Oswaldo Rey
I placed a Maxim MAX16810 38 pin TQFN with a power pad ground on the bottom of the chip on a prototype board FR4 doble sided. Vias of 0.6 mm where placed underneath part, 6 vias in total. Solder was placed with an air operated syringe, land pattern w
Electronics Forum | Fri Apr 29 17:42:50 EDT 2022 | jdengler
It's either a 6 pin DIN of 6 pin Mini DIN. The diameters are different so check that.
Electronics Forum | Thu Apr 28 11:58:23 EDT 2022 | saberbouras
Thanks it's a 6 pins there is a hole on the bottom but it doesn't seem to be a pin, it's just a hole.
Electronics Forum | Wed Jul 08 23:07:18 EDT 2020 | tylerrobertson
Hello, Trying to re-purpose a QUAD feeder for delivering small parts to a scada robot. Wondering if someone could help me out with a pinout for the connector. it's 8 pins Feeder is p/n 12/10-23959B SSA Was able to get the board to power up and flas
.gif)
