Electronics Forum | Fri Dec 14 11:11:46 EST 2001 | Manny Gonzales
Contact Tom Comfort at 512-615-4604.
Electronics Forum | Tue Nov 18 20:03:19 EST 2008 | davef
Here are people at IPC that can direct you to the people you need to talk to about the issues that you have with the standards: * Jack Crawford, IOM, IPC Director Certification and Assembly Technology, crawja@ipc.org 847-597-2893, 847-615-5693 * Dav
Electronics Forum | Thu Jul 27 14:24:10 EDT 2000 | Alan Aben
We are currently working with a ceramic substate boards that come as a eight up panel with a coupon around the edge. I am looking for tooling that can be used to seperate the finished boards out of the panel
Electronics Forum | Wed Feb 18 03:11:23 EST 2004 | Sam
Should I have any concerns with operators using flux for handsoldering, straight out of a 25 ltr drum which is not even thinned dowm to the correct SG level. The flux is Alpha 615-25 RMA based and we use it in our wavesoldering process. Thanks in ad
Electronics Forum | Wed Nov 30 20:38:31 EST 2005 | CEB
You can contact Hitachi High Technologies America, they are still supporting these machines (972-615-9102). It also sounds like you could have a servo problem.
Electronics Forum | Thu May 08 15:53:28 EDT 2008 | radab
I love my Pace ST-30. Not too expensive and works a charm. Tips are also reasonable at $6-$15.
Electronics Forum | Tue Sep 16 21:52:19 EDT 2008 | rayjr1491
10x16 by 5 mil stencil gives me a area ratio of .615 unless I am calculating incorrectly. I will try and attach some images tomorrow. By reducing the Y direction my area ratio s below .6 and I thought this was not advisable. Your help is muc appreci
Electronics Forum | Mon Aug 31 18:18:45 EDT 2009 | smtdrkd
You may like to contact Mike Bixenman of Kyzen Corporation at 615-831-0888 or Ravi Parthasarathy of Zestron Corporation at 703-589-1198.
Electronics Forum | Wed Sep 15 05:15:24 EDT 2004 | Adam
I have chceked the fluxing application, I seem to be getting good consistent coverage across the board using our foam fluxing system. Good flux penetration on the top-side of the through-hole plating, as this was checked using a fax paper.There is no
Electronics Forum | Fri Oct 07 16:39:19 EDT 2005 | pjc
Here are some: Mfr. Model Flash Point Tel Nr. Kyzen Ionox 13400 170 F +1-615-831-0888 Zestron SD 300 106 F +1-703-589-1198 Zestron VD 143 F Zestron
