Electronics Forum | Fri Jan 29 10:53:13 EST 2010 | jeffharley
There are pots on the board in the power supply to adjust the voltages after the machine is powered up. The location of these pots are in the munual supplied with the machine
Electronics Forum | Fri Jan 29 12:59:47 EST 2010 | remullis
Something on the 5v side is pulling it down. I would check every thing associated with the harness you are disconnecting. Your shorting somewhere! Don't have a schematic in front of me. Also look for leads getting into the backside of your connecto
Electronics Forum | Wed Feb 03 18:29:46 EST 2010 | mika
4.85 V - 5.2 Volts. That is on the computer power inlet, Not the on the power supply. /Best Regards
Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Mon Feb 01 14:04:12 EST 2010 | bing007
Found the problem. Thanks for the pointers. I had set the voltage to 5.00 volts as it was reading 4.86 volts. I still had the problem. A slghtly burnt wire going into the spade connector on the back of fuse holder 12 (5 volts). The reason the voltage
Electronics Forum | Tue Aug 23 03:33:46 EDT 2022 | sophyluo1985
6241F Okey？
Electronics Forum | Tue Feb 17 22:26:53 EST 1998 | Larry
I have a Universal 6241A axial lead sequencer. 60 station rotary head. 8222 Controler Insertion rates up to 8,000 components per hour. Asking $80,000 E-mail for more info. larrys@adepttech.com
Electronics Forum | Mon Aug 08 16:49:44 EDT 2005 | slthomas
There's a Universal 6241D on the Equipment Mart page of this site in New Hampshire, and a 6241B in the UK. I've always like Universal, but admittedly that's all I know about PTH AI. :)
Electronics Forum | Thu Aug 08 07:12:25 EDT 2013 | martinouk
Just after some information... We have a Universal Combi6241D and I am interested in knowing if anybody knows of a company or an engineer that is able to offer maintenance and breakdown support? We are based in the North East of England.
Electronics Forum | Mon Aug 23 12:06:37 EDT 2021 | mk15
Hi, I am looking for a an Electrical Service Manual for a Universal Universal sequencer vcd 6241d. thanks
.gif)
