Electronics Forum | Mon Jan 25 17:13:53 EST 2010 | bing007
I am working on a vcd 8 with a problem of loosing the 5 volts supply. We have fitted a new supply that also provides the 15 volts. When we remove the connector on the power chassis for the 5 volts the power supply shows OK. When fitted the 5 volts is
Electronics Forum | Fri Jan 29 10:53:13 EST 2010 | jeffharley
There are pots on the board in the power supply to adjust the voltages after the machine is powered up. The location of these pots are in the munual supplied with the machine
Electronics Forum | Fri Jan 29 12:59:47 EST 2010 | remullis
Something on the 5v side is pulling it down. I would check every thing associated with the harness you are disconnecting. Your shorting somewhere! Don't have a schematic in front of me. Also look for leads getting into the backside of your connecto
Electronics Forum | Wed Feb 03 18:29:46 EST 2010 | mika
4.85 V - 5.2 Volts. That is on the computer power inlet, Not the on the power supply. /Best Regards
Electronics Forum | Wed Jan 26 05:24:56 EST 2005 | SLVito
Morning All, I have to choice between two axial through hole machines: Panasert AVK 3 and Universal VCD Sequencer 8. I will insert axial components with 0,45 mm to 0,8 mm component lead diameter and perform jumper wire insertion in the same machine.
Electronics Forum | Mon Feb 01 14:04:12 EST 2010 | bing007
Found the problem. Thanks for the pointers. I had set the voltage to 5.00 volts as it was reading 4.86 volts. I still had the problem. A slghtly burnt wire going into the spade connector on the back of fuse holder 12 (5 volts). The reason the voltage
Electronics Forum | Wed Sep 11 20:47:50 EDT 2013 | action_101
I forgot to mention the new vcd and radials go for around $230,000 each with only 20 stations. You can buy nice used vcd8 and rad8's between $60,000-$75,000.
Electronics Forum | Fri Jan 16 17:08:35 EST 2015 | travishemen
Yes, both the radial 8 and the VCD 8 run on OS2.
Electronics Forum | Wed Feb 09 10:51:12 EST 2005 | primus
We've got two Universal 6360 series VCD/Sequencers, much older than the VCD 8s out there now. They work AWESOME, provided everybody knows what they are doing. They are not difficult to operate or maintain. When everything's set up right, these things
Electronics Forum | Fri Jan 16 15:29:48 EST 2015 | travishemen
We are trying to network our Universal VCD 8 and Radial 8. I have everything I need except for the driver disks for the Radisys EXM-10A network card. Does anyone have a copy they would be willing to share?
winsouce.jpg)
