Electronics Forum | Sat May 07 15:49:19 EDT 2005 | marcelll
Need a wiring info from somebody who have the schematics for a GSM running the old vision system AIM 3500. There's 2 cables plugging in the vision box, "vision DigA" & "vision DigB" with DB15 connector. I need the pin out of these 2 cables to con
Electronics Forum | Wed Aug 31 17:23:00 EDT 2016 | corepride
Hi everyone, I have a problem with the 630 VME vision system: during startup machine, an error popup appears saying "Did not receive request to load machine model within timeout period. Possible machine error condition exists. Do you want to continu
Electronics Forum | Fri Sep 09 03:51:57 EDT 2005 | geb
Thanks for your help. Yes it is a VME630 Lantern vision system. I'll try swapping the card with the one in the other machine.
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Thu Sep 08 11:56:37 EDT 2005 | siverts
I have seen this before. Sounds like that You are having problem with the vision box, located in the rear left of the machine; that is if you are using the old vision system, the newer Lantern vision card is located in the VME chassi in lower front r
Electronics Forum | Mon Jun 05 07:27:45 EDT 2006 | dwelch123
I have one of these and what I usually do is undersize your measurements just a hair. Also , if you are still using the 3500 vision unit you might want to upgrade to the lantern system. Hope this helps.
Electronics Forum | Wed May 02 11:51:40 EDT 2007 | flipit
Check with Universal on service. The GSM is a solid machine. Very well built. The older machines will run under IBM OS2 OS. Nothing wrong with this OS. There have been some vision system upgrades also. The older GSM might have the AIS3500 or ne
Electronics Forum | Tue Feb 20 06:31:58 EST 2007 | mika
It depends on what VME box build it is. Rev. C, D, E etc. There are upgrade kits for the complete VME chassi and it includes some re-wiring also. For this You must contact UIC and provide them with the machine ser.nr, current Os-system, UPS s/w ver.
Electronics Forum | Fri Jun 01 22:49:50 EDT 2007 | mika
These ones from ALTERA the QFFP-304 0.5mm weight: 32gr. used to give us a really headache in the past. Not only soldering issue:s but also the placement in x-y-theta! The stencil thickness of ours is 0.13mm and because of ohter compomponent packages,
| 1 |
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
