Electronics Forum | Mon Dec 21 10:52:41 EST 2009 | boardhouse
Two other outside labs you can try. Robisan Labatory 6502 E. 21st Street Indianapolis, Indiana 46219 (317) 353-6249 Phone (317) 917-2379 Fax http://www.Robisan.com The Specialty Lab, Inc. 2515 Terminal Road Dock F Roseville, MN 55113 Phone: 651-635-
Electronics Forum | Wed Jul 19 18:24:21 EDT 2000 | Walter
In need of a manual tape splicer that joins togeather all SMD carrier tape. We are running mydata equipment and we need at least a 6" leader on each reel. Who sells such equipment??
Electronics Forum | Thu Jul 20 09:14:02 EDT 2000 | Mike McMonagle
Siemens makes a hand splicer, not sure of the part number. You also need the consumables (clips and tape), which they sell also. You can reach them at 888-SMT-HELP. Mike
Electronics Forum | Thu Jul 20 11:27:48 EDT 2000 | John Thorup
Haven't used it but TopLine sells a hand splicing tool (HRS5) www.toplinedummy.com 800/898-9888
Electronics Forum | Mon Dec 24 09:51:25 EST 2001 | davef
Nicolet Imaging Systems 8221 Arjons Dr Ste F San Diego, CA 92126 (619) 635-8600 FAX: (619) 695-9902 steinmetz@nicimg.com
Electronics Forum | Wed Jan 07 05:53:05 EST 2009 | sm2009
Hello, does anyone know if it's possible to wave solder 0402 components? Are there drawbacks? Where can I find technical details about recommended footprint and glue point? Last question: are there suggestions about wave soldering for ic with 0,635mm
Electronics Forum | Mon May 05 11:20:10 EDT 2014 | pankyb1261
Hi, I was wondering if there is a preferred source of the .635mm ceramic substrate specified in the J STD 002 Test S and if there is what is the typical size folks are using (3" x 3"?). Thanks, Rich
Electronics Forum | Thu Jul 17 11:34:35 EDT 2003 | pjc
� Center board support: - Stationary tension wire - Adjustable width and height position (manual) - Pneumatic raise/lower feature; extends through preheat and solder wave - Minimum board clearance on bottom preheater #1 is 63.5 mm (2.5 in.) with
Electronics Forum | Tue Dec 28 09:52:28 EST 2010 | flipit
Use a 0.002" to 0.003" thick stencil. Use an electroformed stencil from Photo Stencil or one of the others. Use -500 +635 paste or a -500 paste or type 5 or greater paste. I have printed at 0.008" pitch with 0.004" pads. It can be done.
Electronics Forum | Fri Feb 09 03:03:29 EST 2018 | robl
Hi SuMoTe, Maybe a lot cheaper to go to a connector manufacturer and buy your pins from them - most standard 2.54mm pin headers use 0.64mm square pins (0.025" = 0.635mm), that are 12.6mm (0.5") long. Perfect. They will be plated with a solderable
