Electronics Forum | Wed Jan 07 05:53:05 EST 2009 | sm2009
Hello, does anyone know if it's possible to wave solder 0402 components? Are there drawbacks? Where can I find technical details about recommended footprint and glue point? Last question: are there suggestions about wave soldering for ic with 0,635mm
Electronics Forum | Mon May 05 11:20:10 EDT 2014 | pankyb1261
Hi, I was wondering if there is a preferred source of the .635mm ceramic substrate specified in the J STD 002 Test S and if there is what is the typical size folks are using (3" x 3"?). Thanks, Rich
Electronics Forum | Fri Feb 09 03:03:29 EST 2018 | robl
Hi SuMoTe, Maybe a lot cheaper to go to a connector manufacturer and buy your pins from them - most standard 2.54mm pin headers use 0.64mm square pins (0.025" = 0.635mm), that are 12.6mm (0.5") long. Perfect. They will be plated with a solderable
Electronics Forum | Thu Jul 17 11:34:35 EDT 2003 | pjc
� Center board support: - Stationary tension wire - Adjustable width and height position (manual) - Pneumatic raise/lower feature; extends through preheat and solder wave - Minimum board clearance on bottom preheater #1 is 63.5 mm (2.5 in.) with
Electronics Forum | Tue Feb 04 22:28:16 EST 2003 | davef
You could reduce the paste by about 70%. Solder balling and tombstoning will be the issues to fight. The drivers to these don't change with the component size. Use the fine SMTnet Archives for background. Aperture Size and Thickness of Solder Pas
Electronics Forum | Thu Oct 08 18:52:42 EDT 2020 | neosroger
We are looking to improve our SMT Line; We currently have Quad 4C (P&P) CPH; 3600 Capacity: 68 (std 8mm feeders) Minimum Pitch: 0.635mm(0.025") Could you suggest a reliable new Pick n' Place for better CPH and capacity for a value price? We found
| 1 |
winsouce.jpg)
