Electronics Forum | Thu Mar 02 23:09:20 EST 2006 | kmp
If you have a servo or encoder problem you should be getting alot of errors. Are all feet leveled on a stable floor? It wouldn't take much to shake them. A full coke machine weighs more.
Electronics Forum | Sat Mar 04 11:07:21 EST 2006 | charls
hi pavel, If you are getting vibrate during fast mode, encoder or motor cable might be faulty. yes i faced the same problem in Juki KE2010 m/c. Try by replacing encoder & motor cable from Motor to driver unit. All the best
Electronics Forum | Fri Aug 20 18:52:40 EDT 1999 | Gary Kemp
Would like to find out if the nozzles used with the Zevatech FS730 and FM740 component placers are repairable. In other words, is there a way to get around having to cough up $500.00 per nozzle when one gets damaged? Any insight would be greatly ap
Electronics Forum | Tue Nov 19 12:34:33 EST 2013 | jimmyboz
I am not trying to be critical but, you didn't even say Fuji CP-6 problem. There are CP-6, CP-642, and CP-643 machines, are asking 2 model as 642? Anyway, slow the cam speed down in the proper to 40 or 50%. If the problem goes away check the mainte
Electronics Forum | Fri May 30 11:58:16 EDT 2008 | fredc
The right paper incorrectly applied can be a problem also. I have seen it on even new Fuji nozzles with the illumination disk bunched up on one side of the tube with a gap on the opposite side.
Electronics Forum | Wed Jun 01 14:58:45 EDT 2016 | claudea2
I answered my own question. The nozzle changer was in the left front, moving it to the left back fixes the problem.
Electronics Forum | Sun Nov 17 10:50:11 EST 2013 | sara_npi
Hi, I have difficulty on solving unknown nozzle st 17.situation goes like this,almost I run bout 6 models each day,but 1 to 2 models only have this problem.I almost done a few basic troubshoot such as clean censor st 17,clean cluch using prope
Electronics Forum | Wed Jun 01 11:02:57 EDT 2016 | claudea2
I have 3 used Quad 4Cs and the nozzle changer on one machine never worked. I decided to troubleshoot it this week. I repaired the changer by changing a defective optical sensor but I still get error 17 when I try a run-step nozzle 1, 2 or 3. Error 17
Electronics Forum | Wed Dec 10 08:33:08 EST 2008 | lkpdsund
Hello! I have a problem with Assembly Expert 7.3.0. During optimization of the assembleon AX5 an error occurs; The program seems to have a problem connecting the machine library with the component library (device.lib). Even though I have defined th
Electronics Forum | Fri Dec 15 11:01:14 EST 2017 | robertorocco
I have one Topaz X FNC machine with this problem. The head 2 FNC not change the nozzle. The head 4-6-8 is ok and change, but head 2 no, when he tries to change the nozzle he gives me an error message. What could be the problem?