Electronics Forum | Fri Sep 27 10:49:41 EDT 2013 | cyber_wolf
So I am reading about K type thermocouples in the IPC 7530 Guidelines and it says : "At temps above 250c it may suffer from temperature cycling hysteresis and may not be the best choice." Uhhh... It looks like the best choice is an N type thermocoup
Electronics Forum | Sun Sep 29 13:04:58 EDT 2013 | KIC-Tech Service
Sr. Tech, As far as I’m aware, most if not all, manufactures of thermal profilers offer K type thermocouples as a standard for profiling in the electronics manufacturing industry. In my decades of experience in the reflow and wave solder industry, t
Electronics Forum | Mon Sep 30 04:27:40 EDT 2013 | grahamcooper22
I am not sure what the IPC spec is suggesting....K type thermocouples are normally specified upto 1250 C, of course there is a tolerance in their accuracy and this probably degrades after hundreds of uses through a reflow oven, but normally the accur
Electronics Forum | Tue Sep 14 08:16:37 EDT 2004 | davef
Try: 7530 - Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)
Electronics Forum | Thu May 29 12:13:53 EDT 2008 | mikesewell
Profiling is covered in "IPC 7530 Guidelines for Temperature Profiling for Mass Soldering (Reflow & Wave) Processes".
Electronics Forum | Mon Jan 26 15:09:59 EST 2009 | leemeyer
IPC 7530 - Guidelines for Temperature Profiling for Mass Soldering Processes (Reflow & Wave)
Electronics Forum | Tue Jan 08 17:30:16 EST 2002 | davef
Look to 7530 �Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)�. Obtain it from IPC http://www.ipc.org
Electronics Forum | Tue Jan 22 20:37:48 EST 2002 | davef
Try: * Searching the fine SMTnet Archives. We have ground profiling, thermocouple attach, etc. to pulps. * Buying [ http://www.ipc.org ] IPC-7530 - Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)
Electronics Forum | Mon Jul 29 19:21:58 EDT 2002 | davef
Look to: * Your flux supplier's recommendations to baseline your recipe [similar to using your paste supplier's recommendations for setting your reflow recipe] * 7530 'Guidelines for Temperature Profiling for Mass Soldering (Reflow and Wave)' for gui
Electronics Forum | Tue Aug 27 01:11:31 EDT 2002 | zolasteven
Hi Dave, Thanks for your input. By the way where I can find on-line reference on Review IPC-7530 (Guidelines for Profiling) Generally, what is the recommended frequency for conducting temperature profile? Thanks & rgds, Steven
.gif)
