Electronics Forum | Wed Sep 10 06:58:30 EDT 2003 | fpcb
these machines are controled by a panadac 783 which has memory for 8 programs. How you can control these machines by a computer ? There is ,as I have heard, a Panasonic program host. what can it do , Is this the solution ? Thanks John
Electronics Forum | Sat May 27 14:09:23 EDT 2000 | do ngoc hung
MAY YOU HELP ME TO SOVLE THE PROBLEMS IN MACHINE. I CAN NOT CHECK NOZZLES IN CENTER, BRIGHTNESS MODE OR THE CCD CAMERA CAN NOT CAPTURE THE NOZZLES. SO MAY I HAVE ANY INFO ABOUT IT. PLS GIVE ME A ADVICE ASAP VIA EMAIL. THANKS AND BEST REGARDS. DO
Electronics Forum | Tue Sep 22 15:30:29 EDT 1998 | Rob Williams
| I'm looking for information on "volcano" soldering or mini-wave soldering. I need to solder a leaded device, thru-hole, on a already populated smt PCB. I want to do localized soldering on the pins of the device. | Any help would be greatly appreci
Electronics Forum | Wed Jul 01 11:33:30 EDT 1998 | Upinder Singh
Hi all. I am trying to put one 20 pin thru hole connector along with the smt components on the PCB. I would appreciate if somebody can guide me in getting thru this process. I also need to know how much bigger the holes on the screen or stencil shou
Electronics Forum | Wed Jan 21 09:33:41 EST 2009 | pigsinspace
Ok. As you know the machines changed a bit after 95 due to CE regulations. There are no drawing on board/box level in Panasert machines. However normaly i`ts the 100 volts thats "shorting out" the machine and shuts it down. Check all cooling fans a
Electronics Forum | Fri Mar 15 20:56:55 EDT 2013 | marcelorotofrance
At this point all the sensors, switches and solenoid valves were checked. Their electrical signals and actions were phisically checked at the I/O cards level (Panadac 783-065 and 065A). Above mentioned signals were monitored from "I/O Monitor" functi
Electronics Forum | Fri Jul 03 09:29:19 EDT 1998 | Dave F
| Hi all. | I am trying to put one 20 pin thru hole connector along with the smt components on the PCB. I would appreciate if somebody can guide me in getting thru this process. I also need to know how much bigger the holes on the screen or stencil
Electronics Forum | Tue Jun 30 12:48:59 EDT 1998 | Upinder Singh
Hi all . Thanks to Ryan, Brian , Justin and Dave for the timely help earlier. I would appreciate if somebody could help me in the stated issue: I am trying to to place one thru hole 20 pin connector along with the SMT components by paste printing an
Electronics Forum | Fri Jul 10 14:23:23 EDT 1998 | Bob Willis
You can get a report and CD ROM on pin in hole reflow assembly from the SMTA main office in the USA. They also have a new report on Double Sided Reflow Design and Assembly. | Hi all . | Thanks to Ryan, Brian , Justin and Dave for the timely help ear
Electronics Forum | Wed Jan 21 10:27:27 EST 2009 | gidster
Ok. As you know the machines changed a bit after > 95 due to CE regulations. > > There are no drawing > on board/box level in Panasert > machines. > > However normaly i`ts the 100 volts > thats "shorting out" the machine and shuts it > down. C