Electronics Forum | Wed Aug 26 17:59:09 EDT 2015 | gleblonc
Hi, There are some good training manuals available, you can likely get them buy going to support.acculogic.com or emailing to support@acculogic.com. The manuals are also in the installation folder and help files, but often speaking with a support per
Electronics Forum | Fri Jun 04 14:03:18 EDT 2004 | Frank
I know Juki has the headquarters in NC, but they have a support office in the Silicon Valley with spare parts. I know they go to the NW area quite often from that office. They offer their customers 7-day/24-hour free phone support (including holida
Electronics Forum | Tue Jun 14 10:48:03 EDT 2005 | Paul
We evaluated several machines a couple of years ago and ended up selecting an Agilent SJ50. Fast machine but very limited on joint inspection. Also does not detect missing components reliably which you would normally take as a given on an AOI system.
Electronics Forum | Sat Jan 11 17:06:27 EST 2020 | silverlead
I have worked with both Gridlock and conventional pin support mostly on DEK machines. Gridlock allows to reduce greatly changeover time in hi mix/low volume environment when switching sides on double sided boards. It also eliminates guesswork when ma
Electronics Forum | Wed Apr 26 11:50:18 EDT 2000 | Wolfgang Busko
Hi Sal, the way you do it has IMO some advantages: - no sophisticated support for the topside print - no extra thermal stress for the the bottomside bonding material - less possibilities to lose bottomside components by handling One disadvantage mig
Electronics Forum | Wed Dec 01 07:48:57 EST 1999 | Steve
Wolfgang, For most of our products, we use a 3-up panel. However for each PCB in this panel we will have a support problem beacuse of the components close to the edge. The framepiece you mentioned - is this something that would come from the PCB su
Electronics Forum | Wed Jan 24 09:52:50 EST 2007 | electronhose
Sounds like you need a support pallet to accommodate the narrow side clearance. Several pallet houses made pallets that work in screen printing that have flush board edge clamps that hold the board in the pallet yet allow the stencil to come all the
Electronics Forum | Fri Jan 29 10:03:25 EST 2010 | jamyboy
The SMT MFG Process for Flex circuits is relatively the same as traditional SMT process, the key is your PCB supplier. The good flex circuit shops will supply the circuits in a rigid carrier or if Rigid/Flex the supplier will create a support structu
Electronics Forum | Thu Mar 19 21:56:12 EDT 2015 | gabinocf
Hi guys, i do not have a lot experience on this wave solder process, in my plant now i have the opportunity to work in this area, and a lot issues are been happening on the process and it could be possible that i request information about this, i hop
Electronics Forum | Tue Feb 28 09:22:12 EST 2006 | Mity-C
We have just had gridlock installed on 4 DEK screen printers. I agree that if it partially catches a component you will have misprints. In the same respect, if a hard pin is placed in the wrong location, you will get misprints and or damaged componen
.gif)
winsouce.jpg)