Electronics Forum | Mon Sep 28 14:02:15 EDT 2009 | swag
As mentioned previous, check all fuses & breakers. In the AC chassis (should be under black cover beind front, right door), remove cover and check main circuit breaker. Also should be two fuse housings next to breaker - if they are lit up amber, th
Electronics Forum | Wed Jun 03 06:45:38 EDT 2009 | aj
machine wont initialise after breaker tripped when machine was powered down over the weekend. All PSU's check out fine along with Estop circuit. I get the command to press system button but thats as far as it goes. any ideas welcomed
Electronics Forum | Tue Sep 29 14:54:03 EDT 2015 | bmalhi
Voltage retrofit require some wiring changes along with circuit breakers replacement. Please contact serviceNJ@hellerindustries.com to get the retrofit quot.
Electronics Forum | Tue Jul 02 14:51:01 EDT 2024 | linux
We use both the ct930 and 1040, we are not impressed, we ended up retrofitting due to excessive heat being produced at the circuit breaker side of oven, Ended up installing several door fans to reduce the heat. also the oven was supposed to be able t
Electronics Forum | Sat Sep 26 02:09:39 EDT 2015 | aemery
Proc My field service back ground included Electrovert so I know reflow electrical quite well. I've worked on Heller, Conceptronic and Vitronics over the last few years and really there isn't a huge difference if you can read a schematic. I checked
Electronics Forum | Wed Apr 07 11:21:26 EDT 2004 | stefwitt
Hi Dilbert, it is a step up transformer from 3 phase 208 to 3 phase 380. Each machine does not draw more than 3 Amps per phase. However, circuit breakers are rated at 15 Amps. The transformer has three power outlets, each one has a Perilex (European)
Electronics Forum | Thu Jun 28 18:50:08 EDT 2018 | caurbach
We don't have your exact machine or know your exact configuration, but our machine has occasionally gotten an estop due to a breaker in the SelectX tripping. Just be aware that there are circuits other than the mushroom switches that can generate an
Electronics Forum | Wed Aug 07 13:32:21 EDT 2019 | rgduval
To isolate the MOT failure, try swapping the MOT card with another MOT card. If the failure moves, then the problem is in the card. If the failure does not move, the MOT card is not your problem. If the MOT card is not the issue, then your problem
Electronics Forum | Thu Dec 31 12:21:44 EST 2020 | ecogroup
I Changed old parts to New Parts for: All 5 Magnetic Contactors, Circuit Breaker/Protector 1, I/O Switch housing + contact blocks, both 12v and 110v relays. Still CP40 contactors won't engage after I/O Switch is pressed, G9D-301 Safety Relay Power Le
Electronics Forum | Mon Feb 07 19:49:50 EST 2000 | Tony Di Mauro
Jose, I have seen this defect before. We called it re-reflow. We found the part was originally attached at SMT. Later on after seeing a heat cycle at the wave machine the leads would de-attach causing an open at In-Circuit Test. Resolution was t
Midwest Circuit Technology provides Carbide Router Bits and End Milling Cuters for use in PCB Depaneling equipment. We have over 35 years of supplying tools and machining experience in drilling, Routing, Test Fixture manufacture.
114 Barrington Town Square
Aurora, OH USA
Phone: 13309956900
winsouce.jpg)
