Electronics Forum | Mon Nov 06 05:24:37 EST 2006 | BAJAJA
Knows anybody this company? Please let me know about your experiences? http://www.microcirtec.de/proc2.htm
Electronics Forum | Tue Nov 14 19:53:31 EST 2006 | davef
More information please. Tell us about: * Board solderability protection * Your process and materials * Breadth and scope of the problem
Electronics Forum | Wed Nov 29 09:25:42 EST 2006 | russ
So why are you telling us about the solder bar? What is the flux? that is what you need to change, you have a rosin based flux it sounds like. you can change probes in test fixtures or change flux chemistries. Russ
Electronics Forum | Wed Nov 29 14:49:38 EST 2006 | MS
Any recommendation to reduce solder beads next to 0402, 0603 and 0805 caps and res? What about home plate vs. bow tie stencil aperture design?
Electronics Forum | Tue Dec 05 08:23:14 EST 2006 | davef
How about a stepped stencil? Not ideal but ... As far as overprinting goes, try: http://www4.uic.com/wcms/WCMS2.nsf/index/Resources_44.html
Electronics Forum | Wed Dec 06 06:09:02 EST 2006 | Loco
Would say about the same as above, 8mm according to a cookson presentation we had, of course it would depend a bit on the paste you are using.
Electronics Forum | Fri Dec 08 00:02:35 EST 2006 | Jack
Hi all, I found this article (Dealing with "the black pad defect)about reworking bare PCB with black pad symptom...Use HASL to treat black pad..Have you guys try this before?? www.smta.org/files/SMTAI01-Jay
Electronics Forum | Fri Dec 08 18:59:59 EST 2006 | Jack
Re-address the link... http://www.smta.org/files/SMTAI01-Jay.pdf Look at the last page about bare board reparing..
Electronics Forum | Thu Dec 07 19:04:02 EST 2006 | chrisgriffin
Chunks, your right, I need to get out more. What are you doing Saturday night? Harry is right about the software version compatability with trackballs. What is the version and machine type?
Electronics Forum | Thu Dec 07 12:22:50 EST 2006 | jimby
We have our circuit board vendor put a solder mask dot over the vias after HASL process. It's a little more expensive but eliminates the problem that you are talking about.