Electronics Forum | Mon Aug 19 15:21:17 EDT 2013 | marcelorotofrance
Hi Rollon, thanks for your answer. At this point it seems that cold-start current surge, because the presence of large value capacitors in the power source, exceeds the sensitivity of the protection switches rather than a malfunction. Nevertheless, i
Electronics Forum | Fri Aug 16 03:13:32 EDT 2013 | rollon65
Hi Marcelo. I have used 2 non EU model 4C machines since 2002 that do this almost every time from a cold switch on. My local Tyco tech guy said that they all do it. They are still going after 12 years. I have another EU machine that does the sam
Electronics Forum | Wed Aug 07 16:56:32 EDT 2013 | marcelorotofrance
When I turn the machine on, almost every time I turn the Motor Power Switch it trips. I must to put the lever down and raise it again, then every runs normally. I asked to the former owner about that and told me that this machine always did it so and
Electronics Forum | Thu Sep 12 20:55:39 EDT 2013 | marcelorotofrance
My own unit has an internal transformer also. It has multiple secondaries, and a divided primary which can be configured to the required voltage by changing jumpers. Best regards.
Electronics Forum | Fri Sep 06 02:34:37 EDT 2013 | rollon65
Hi Marcelo The two machines I mentioned are the American type but they have an internal transformer fitted to convert from 110 to 220 Volts for U.K. Incidentally only one of the machines does it on a regular basis whilst the other one is mostly O.K
Electronics Forum | Wed Feb 07 08:41:10 EST 2001 | dliechti
I have to design a power supply which converts 220V AC into 5V smothed DC. It has to be very small, so it shouldn't have a big transformer. Has somebody a scheme of a circuit? Thanks
Electronics Forum | Wed Apr 30 08:03:25 EDT 2008 | chineechooze
You need switch out the cognex vision card.
Electronics Forum | Mon Jan 06 05:53:47 EST 2020 | richardcargill
First switch on after the holidays and this year it's the Dek265 playing up. On switch on, the screen comes up with "motor comms failure, card 0 axis123 " . On looking at the cards there seems to be a power feed missing ( see attached pict
Electronics Forum | Mon Aug 06 05:12:20 EDT 2007 | wayne_
Hi Is there any standard or requirement to test the solder under high power operation? For example, a power switching device, what is the failure mode of the solder joint after the whole equipment undergone a high power (current / voltage) environmen
Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr
DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit