Electronics Forum | Wed Dec 03 11:35:15 EST 2008 | wrongway
We have an ac30l advantis machine with a lighting head for about a year now we place a lot of 0603 parts some from vishay we are not seeing this problem yet
Electronics Forum | Tue Sep 07 09:53:37 EDT 2004 | rob
Hi Dhanashekar, I'm with Chris on this one, unless you are carrying out 0201 or ultra fine pitch placement it's a helpful but not critical tool. We found most print errors were avoided using the 2D vision on the printer, combined with plenty of aut
Electronics Forum | Wed Aug 08 14:32:50 EDT 2012 | leemeyer
According to Quad data sheet, the max process temp on a ZCR oven is 310C. I am taking a guess that the "Critical Temperature" message may be Quad's way of saying that you have entered to high of a setting. Try bringing the setpoints to something belo
Electronics Forum | Wed Sep 20 10:05:10 EDT 2006 | SWAG
Not familiar with 3C/4C but if the head is similar design to Samsung then you might consider flushing the tubes and airlines that go to the nozzles. We used to disconnect the airlines at the top and run cleaner down through the tubes. We would then
Electronics Forum | Fri Nov 10 09:09:48 EST 2006 | russ
That is great point John, it definitely gets you closer to apples vs apples. Remeber one time when we were compared to a another Mfgr that made a square box of plastic for one of our customers we made the PCB the fit into that box, we had wires, fi
Electronics Forum | Wed Jul 14 17:33:04 EDT 2004 | Ross Clunie
The short answer is "No" the white and green feeders are not interchangble. The green feeder has a channel in it to allow the "embosed" or plastic tape to fit flat at the pickup position. If you use paper tape in this type of feeder the tape can be d
Electronics Forum | Sat Sep 22 01:30:31 EDT 2007 | mika
I am sorry my friend, but I can't recall that specific error number. But it would help if you explain a little bit more about your problem. Remember that an error code Do Not necessary points to a direct root-cause of a problem. First of all we nee
Electronics Forum | Wed Apr 27 11:43:32 EDT 2005 | patrickbruneel
Hi Daan, What we did in the time was pareto analyses on all board designs to determine the critical areas (mainly design errors) and only inspect those specific problem areas. Every batch had a copy of the PC board with problem areas marked and only
Electronics Forum | Tue Jun 15 14:45:11 EDT 1999 | C. Cross
| I am looking for more information about: | | 1) What kind of evaluation can I do to measure the resistance to fall off of a bottom side glueded SMT component?; | | 2) There is some influence of doble wave solder machine (temperature, flux, etc) i
Electronics Forum | Thu May 26 13:53:45 EDT 2005 | gregp
I wouldn't worry about patents except for those types of feeders which have patents such as the MyData Agilis feeders. I would worry about cost of tooling for $tampings. Long time for ROI there. Also pay attention to the burr side and shear side of
