Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Wed Jun 25 18:19:49 EDT 2014 | guts1872
During machine run, sometimes when we stop to change parts the servos wont start back up. There is a message on the screen that says "Amplifier is resetting power". When that message clears and push the servo on button nothing happens. There is an er
Electronics Forum | Thu Jul 10 19:26:21 EDT 2014 | guts1872
It looks like we did have an interlock problem. Maintenance re possitioned them and it seems to have cleared up our problem. For some reason when we close the door, it still wants to reset the Amp power, but if we wait for the all clear in the GUI be
Electronics Forum | Mon Apr 16 13:31:36 EDT 2012 | jdengler
Have you tried to restart F4G and/or MCS/30 after flushing the CP4 memory? I have occasionally ran into the comm error after a reset start. Leave the machine on and restart F4G or the MCS/30 whichever normally is hooked up. If it still won't commu
Electronics Forum | Tue Aug 15 10:55:23 EDT 2006 | chrisgriffin
Some software versions won't allow a brightness change with the next button. You should do a histogram test. Place a board on the worknest, then a smooth white card on top of that. Then jog the camera over the card. Raise the Z-axis to it's softwa
Electronics Forum | Wed Jun 09 10:41:28 EDT 2010 | chrislyttle
We've been having some problems with out Fuji IP2E machine that we've recently bought from a company that is no longer operating here. Since installing it we've encountered a few problems with it starting up. To give you a quick breakdown of its be
Electronics Forum | Thu Jan 12 16:32:35 EST 2006 | Cmiller
The lightning head will place parts up to 30mm square but there is a height restriction and it will only pick from tape feeders, no trays, no vibes. It will put down QFP's at full speed and the placements are dead on. I think you need an optional p
Electronics Forum | Tue Nov 11 18:41:21 EST 2003 | mantis
Hey all, Anybody out there able to shed some light on the above error.My Mpav powers up with this error and wont let me do anything the manual is not much help either. Regards, Mantis
Electronics Forum | Mon Dec 17 09:59:50 EST 2018 | crstarr
Hello - We have two Quad QSA-30As that won't boot. These two machines haven't been run since October (they are backup machines), and there were some heavy lightning storms that month. We think both mother boards may have been zapped. We replaced
Electronics Forum | Thu Aug 22 13:31:23 EDT 2013 | bvdb
Re-doing this thread as original seems to have been shortened. Our beloved 24 year old Fuji IP-1 fine placement machine won't start. Has been working fine for the past 6 years but now when the Power button is pressed the power comes on but the FAIL
.gif)
