Electronics Forum | Tue Mar 30 06:27:22 EDT 2010 | ristikas
It happens on the middle of the stecil cleaning. The camera and the cleaner will stay under stencil in half way back. Then machine asking the initate the motors. If to press initate then the pcb stopper will hit the rails. Usually we move camera and
Electronics Forum | Fri Jul 18 10:10:21 EDT 2014 | proceng1
We've got an MPM Accuflex printer that generally works great, but we've had a recurring problem. The powered rail (rear rail) fails to initialize. Sometimes all it takes is restarting the machine to get it to work. At the suggestion of the repair
Electronics Forum | Fri Dec 17 09:49:34 EST 2010 | remullis
Hello to all, I am having problems with the X,Y table initializing. I noticed the Skew motors 17M1 and 17m2 are moving but the table keeps wanting to drive in the left direction standing in front of machine. It will keep trying to drive until it tim
Electronics Forum | Mon Jul 21 11:01:11 EDT 2014 | dontfeedphils
I dealt with the same issue for a month or so. We jumped through a lot of hoops, replaced both lead screws, verified the motor was good, a ton of stuff. Ended up being an intermittent wire connection between the control board and the conveyor width
Electronics Forum | Mon Dec 20 04:41:38 EST 2010 | accuspares
Hi, The input indicators can be located by selecting the 'Input' page located in the 'Diagnostics' drop down menu. Just select the Align tab at the top of the page and you'll be able to see when the nearly home and home sensors change state. The pr
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
Electronics Forum | Mon Jul 29 09:19:00 EDT 2002 | pjc
Quick Change Tooling is one advantage for DEK when comparing the MPM UP2000. DEK has Form Flex. Good system, but I've heard concerns about long term dependabilty. All support tooling options offered on the UP2000 takes a bit of time to set up. So, If
Electronics Forum | Mon Jul 21 06:18:15 EDT 2014 | digar
We had this. The anti-backlash nuts were binding. > We took them apart, chased the threads with a tap > and re-assembled with slightly less pre-load. > Hasn't been a problem since. > We had this. The anti-backlash nuts were binding. > We took t
| 1 |
winsouce.jpg)
