Electronics Forum | Fri Mar 05 12:24:34 EST 2021 | astarotf
Hello Our problem was the camera that was bad, we replaced it and it worked again, greetings!
Electronics Forum | Thu Mar 04 22:38:54 EST 2021 | tomek_k
Hi Miałem taki problem, myślałem też że to uszkodzona karta Cognex. Zakupiłem nową i to nie pomogło. Okazało się że trzeba zainstalować właściwy sterownik karty. (translate from PL) regards Tomek
Electronics Forum | Mon Feb 10 08:18:18 EST 2020 | astarotf
Hi We have an Accuflex MPM with camera vision problems which shows no image, only the screen looks gray. With the diagram we show that our MPM camera is receiving the appropriate 12V voltage on pin # 6 of the camera and supplies the video output on p
Electronics Forum | Thu Aug 13 14:52:42 EDT 2015 | deanott
We just encountered a problem with the vision on our MPM Accuflex. We just switched jobs and when we went through a 'Vision Set-up' there was no image (just blank gray screen where you'd normally see the PCB or bottom of stencil). When we tried to
Electronics Forum | Thu Aug 13 16:08:01 EDT 2015 | capse
I don't believe the lighting and camera have the same power supply. You have no image. The likely issue is the camera power supply of the camera itself.
Electronics Forum | Thu Aug 13 16:47:06 EDT 2015 | deanott
Thanks for your reply. I have very little documentation for the machine. Any idea where the camera voltage might be detected/measured or where the PS for the camera is located? Is it part of the camera assembly?
Electronics Forum | Mon Aug 17 11:05:44 EDT 2015 | capse
An excellent example of a technical answer from sales verses service! At least I started him in the correct direction.
Electronics Forum | Mon Aug 17 11:29:41 EDT 2015 | deanott
Thanks for the useful instruction. We did find a loose connection. It was the connector right at the camera/PCB. I believe it was bumped when placing board supports (going forward we'll move the camera to the rear when placing board supports).
Electronics Forum | Wed Jan 22 08:59:40 EST 2020 | borisanic
I need to calibrate vision offset of MPM Accuflex printer. According to manual I need the calibration stencil with 49x49 holes. Does anybody know what is the approximately diameter of those holes and what is the distance between rows and columns?
Electronics Forum | Mon Feb 12 12:51:19 EST 2018 | dleeper
Yes, the vision system in the MPM accuflex, as well as on other MPM printers is reversed. It's kind of weird but you get used to it.
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723
.gif)
.gif)
