Electronics Forum | Wed Jul 07 12:57:24 EDT 2021 | emeto
One of these ACE KISS machines. Very basic and simple to program. It is a great entry level machine. However, accuracy and repeatability not the same compared to the big expensive machines.
Electronics Forum | Wed Jul 07 16:15:54 EDT 2021 | bobpan
We have an Ersa and an Ace machine. The Ersa is made for bigger volumes of boards. Programming is longer/harder and not as user friendly. If your running 100 boards or less.....the Ace is the way to go. If you need flexibility the Ace is better.
Electronics Forum | Thu Feb 07 12:50:21 EST 2019 | gregcr
Hi All, What are you running for selective solder flux? I'd like any opinion on water soluble and/or no-clean fluxes you are using. In our Kiss 104 machine we use HYDRO-X20 water soluble flux, per the original install suggestion, but I'd like to k
Electronics Forum | Tue Jul 02 14:35:50 EDT 2024 | proceng1
Nordson bought ACE, and then NORDSON dropped support. TMSSOLUTIONS .US is supporting them now. Some of the former ACE employees started a company and acquired the spare parts and documentation from ACE. Ryan is the guy to talk to. Have your machin
Electronics Forum | Fri Jun 28 08:13:09 EDT 2024 | atpico
Hello, In technical specifications for ACE KISS selective soldering machines it is written : Power International: 208-230VAC / 1Ph/60Hz 8 amps Question 1: this must be equipped in Factory, or it's custom selectable on the machine as for many ot
Electronics Forum | Fri Jun 28 14:20:32 EDT 2024 | mistrthou
Ours may be different, but the back power plates (yes, there's two) show 2082/220v 50/60Hz 30A and 115/120v 50/60Hz 15A Thinking the frequency won't matter. You'd be a bit above the high side of voltage. How did you end up with a KISS over there? Th
Electronics Forum | Fri Mar 17 12:00:52 EDT 2023 | previnmoore
Its the kiss 103 selective solder machine. The end of the travel, it's the x axis. when i tried jogging it nothing happens just makes a noise. Thanks for responding.
Electronics Forum | Fri Mar 17 14:59:50 EDT 2023 | proceng1
OK, does your axis screw have the flex coupler or the magnetic coupler? Which axis is it? Did you turn off soft limits? If it's out of range, soft limits won't let it move by controls. I need to know which axis before I can get too far into this. I
Electronics Forum | Thu Oct 15 18:31:32 EDT 2009 | swag
You should take a look at these guys, also: www.ace-protech.com We have one of their machines and its been great.
Electronics Forum | Fri Mar 22 14:07:00 EDT 2019 | proceng1
I believe that NORDSON now recommends AIM NC277. Nordson bought out ACE-protech.
