Electronics Forum | Mon Jun 29 07:17:25 EDT 2015 | donlockard
Seho maxi wave 3240 should be considered as well. Invented full tunnel nitrogen systems that have lower operating costs and provide yields unlike what can be achieved by air wave systems.
Electronics Forum | Fri Aug 21 09:36:50 EDT 2015 | esoderberg
Looking for better design information than is contained in IPC 7525A. Specifically the minimum trough width and length of the step to achieve the necessary paste reduction.
Electronics Forum | Thu Aug 27 16:44:11 EDT 2015 | esoderberg
I have that article. While some of the information is helpful, there is no direction as to the length and width of the step to achieve blade deflection to reduce paste.
Electronics Forum | Thu Feb 25 09:18:05 EST 2016 | tombstonesmt
Have you looking into acrylic? We've had huge success with boards with stringent keep out areas while achieving proper thickness. Acrylic requires a thinner or cutting agent to perform repair/rework. -TSS
Electronics Forum | Fri Feb 03 11:47:29 EST 2017 | lleonard
Is this for a Selective Solder? If so what size nozzle do you run. I run at 315 C most of the time. You can speed up your process time and still achieve good solder fill.
Electronics Forum | Thu Aug 10 11:36:13 EDT 2017 | dhanson
Hello, I am looking for information regarding the history of the development of automated optical inspection technology from when it was first conceived to today. I would generally like a timeline from milestone achievements that really progressed t
Electronics Forum | Fri Oct 06 01:08:17 EDT 2017 | tsvetan
potting the board with epoxy will make it non repairable the same insulation effect you would achieve if you just put around the inductors some styrofoam or other sound insulator without messing with epoxy
Electronics Forum | Mon Jul 01 04:50:04 EDT 2019 | sssamw
Yes, No standard.Normally QFN supplier suggest 50-75 um (2-3 mil), but it's very hard to achieve and hard to make consistent stand-off in prodution.
Electronics Forum | Mon May 13 02:14:04 EDT 2019 | tsvetan
All these generalizations are non sense. What real cph you will receive depend on many factors: - paths optimization - what number of feeders are used - what number of nozzle changes has your job - how fast is the recognition for small and big part
Electronics Forum | Thu May 09 14:05:43 EDT 2019 | SMTA-Joe
Thanks for the option. Might be a good resource if we cannot achieve what we're looking for.
