Electronics Forum | Fri Sep 08 12:03:24 EDT 2017 | rameshraja
Hi, I need the RF 800 Flux Acid titration procedure and also require EPT of the same to add thinner ( RF 800 additive), i.e we are using the flux rf 800 for our wave soldering process having foam fluxer , after 2 hours we are taking sample from the
Electronics Forum | Thu Jul 25 14:32:55 EDT 2019 | bulur
What does flux acid value means in SMD and PTH applications? Is it higher acid values better for each application?
Electronics Forum | Tue Nov 13 21:59:42 EST 2007 | davef
This processes has the potential to cause barrel cracking and pad lifting, because the heating is very hot [troop crank-up the volume on their iron when they see thick boards] for a relatively small area on one side of the board. What do we suggest
Electronics Forum | Fri May 05 14:30:11 EDT 2000 | C.K.
I'd have to disagree with the Electrovert applications guy. I'd recommend SLOWING down the conveyor between .5 to 1 FPM - effectively, you're REDUCING contact length (because contact length = dwell time * conveyor speed), hence getting better peel-o
Electronics Forum | Sat Dec 02 12:03:40 EST 2000 | Jamey Butteris
If you put a 6v battery on a 12v solar panel, it will charge the battery. It will also overcharge the battery and may damage the plates if you leave it on too long. The 'float' voltage for a lead acid battery (6v) should not exceed 7.2 volts for exte
Electronics Forum | Fri Jul 31 09:12:35 EDT 2009 | gregoryyork
Dear Sean Contrary to believe MOST formulators of No Clean fluxes or No Residue fluxes use organic acides that are in fact weak and benign. IF the residue was left on the board and you had a condensing atmosphere then you may see some issue with fal
Electronics Forum | Thu Jun 22 14:57:34 EDT 2000 | Lee
Mike, when you ask if companies afford to place additional environmental constraints on the manufacturing process, perhaps we should ask whether they can afford not to pay attention to environmental issues. I know this sounds a little flippant, but i
| 1 |
