Electronics Forum | Wed Nov 18 10:37:04 EST 2015 | sarason
Are yu sure this is not a power FET. Is this inside the Laptop or in the Power adaptor sarason
Electronics Forum | Thu Mar 31 15:53:23 EDT 2022 | stephendo
And pin outs of both. Once I saw a SOT-6 replaced with a miniSOT-6 (IIRC) The pin outs of the two parts were different. We did make an adaptor board and it wasn't too bad. We populated a panel of the adaptor boards, depanelized them and put them in t
Electronics Forum | Thu Sep 19 07:55:41 EDT 2002 | Claude_Couture
Dilbert, You are both right! Just above the schematic in the Smema standard it says: "Conformance to the standard may be achieved by the appropriate design of the equipment or by providing special adaptors which enable the equipment to meet the stand
Electronics Forum | Mon May 02 11:00:34 EDT 2005 | jh0n!
Unfortunately, we don't have that option under Utilities. Must be UP-2000 specific. I've set everything up correctly, multiple times...All the right dimensions, etc, taught fids, and it still tries to load the board in the wrong position. As far a
Electronics Forum | Mon Dec 06 11:26:14 EST 1999 | Peter Brant
Does anyone out there know of an adpator I can fit to a SOP48 footprint that will accomodate a TSSOP48 device?
Electronics Forum | Tue May 03 21:46:13 EDT 2005 | KEN
I have 5 of these machines. What software version are you running. 24 inch frames will interfere with the USC. The solvent bar will ride on the stencil frame. This will not allow for a pre-load on the foil. 1. Adaptors suck! 2. Adaptors suck! 3
Electronics Forum | Thu Mar 18 08:23:33 EDT 2021 | robl
Yes, we did it with both the monitors (camera & normal). Used a BNC to VGA adaptor for the black & white camera.
Electronics Forum | Tue Jul 13 11:21:28 EDT 2021 | stephendo
You may have to use an adaptor board. A small board with one footprint on one side and the other on the other side. Do not assume that the pin outs of the two parts are the same. I have seen smaller parts with a different pin out than the bigger part
Electronics Forum | Tue Jan 11 11:38:25 EST 2022 | spoiltforchoice
Tool box with a marked home for every tool and adaptor, if its not in use its in its home, anyone caught with it on their desk because "I was using it yesterday" gets a slap. Some would call that LEAN methodology I believe.
Electronics Forum | Thu Mar 13 10:41:13 EDT 2008 | slthomas
I don't know who's driving the bus there, but I personally would just tell my boss that it couldn't be done without: (1) compromising the quality and reliability of the product (2) increasing the cost to manufacture the product (3) increasing the scr
