Electronics Forum | Sat Oct 03 15:51:06 EDT 2015 | amrsalama
I have the same problem and while using logicomm it gives an error message (FC107F24) !!! how can I read this error to address the problem ???
Electronics Forum | Tue Oct 06 20:18:27 EDT 2015 | edwaterfall01
With the address of FC107F24 I would look at the Slot 11 UIMC board. Try swapping with another Radisys Board. Check jumpers, changing one jumper only on each board.
Electronics Forum | Wed Aug 12 11:01:37 EDT 2015 | bnorton
Machine->Config and set all their addresses to 0. We have swapped the EPC5, the VGA Video, the Force board, and most recently the Lantern 630VME. Watching the Force board COMM2 with Logicomm, at the end of all the ldx file processing it changes to c
Electronics Forum | Sat Aug 08 09:45:11 EDT 2015 | edwaterfall01
It would be helpful to know what happened before the error occurred. Do you have another machine so that you can swap some boards? The Force CPU, (machine controller) located in the VME, is responsible for controlling all machine-related activities.
Electronics Forum | Wed Aug 12 18:06:33 EDT 2015 | bnorton
Here's the end of Logicomm capture on Force COMM2 where it starts the Lantern system not active messages. Couldn't get attach to work. Startup and earlier .ldx file loading omitted ulLoadTasks(): Opening the RFS pseudo device driver ... ulLoadTas
Electronics Forum | Mon Dec 06 21:57:09 EST 2021 | compit
make an IP address reservation for the MAC address of the machine on the DHCP server
Electronics Forum | Thu Jul 14 04:11:16 EDT 2005 | zsver
What is written on the display at error type and error address. from error address you can find out where the error comes from.
Electronics Forum | Mon Dec 06 21:38:22 EST 2021 | erici
Thanks victor, will go with your suggestions. By the way, would you happen to have some info on how to work the MC distributor? When i was working on the hard drive of the machine i was able to re install the MC software on a fresh harddrive, as i u
Electronics Forum | Fri Aug 07 18:09:55 EDT 2015 | bnorton
The power distribution board has 10 green LEDs on. By the time of the error SysFail is still on. Logicomm connected to the Force board COMM2 shows a stream of messages saying "Lantern system not active. Heart Beat = 0"
Electronics Forum | Wed Aug 12 14:06:25 EDT 2015 | bnorton
We tried restoring the Machine Configuration, Mapping, and Calibration data from after the calibration done last year. The error was still present after the restore and restart.
