Electronics Forum | Fri Aug 10 13:52:58 EDT 2001 | davef
When you say that glue viscosity changes for lot to lot, is this LOT TO LOT of your product OR Loctite�s product? And when you say that glue viscosity changes, what do you mean [eg, increase by � , decrease by � , er watt?]. What specifically is th
Electronics Forum | Tue Jan 16 16:59:39 EST 2007 | realchunks
Pallet angle is usually pretty good. Lead length is also another good thing to keep as short as possible. Air Knives don't work that well. Also check your board. Make sure you have solder resist between each and every thru-hole pad. If the board
Electronics Forum | Tue May 05 13:38:51 EDT 1998 | Chrys
| | I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | | Here's the part that seems weird to me: | | -They didn't tombstone onto a termination - they went onto their sides! That's right, bo
Electronics Forum | Fri May 15 09:20:34 EDT 1998 | Earl Moon
| | | I've never seen this before. Today, I got this tombstoning on Tantalum Capacitors (Okay, I saw that before) | | | Here's the part that seems weird to me: | | | -They didn't tombstone onto a termination - they went onto their sides! That's rig
Electronics Forum | Fri May 14 11:17:42 EDT 2004 | Ashok Dhawan
I am having coating adhesion problem with flex circuits. The cover plate material is KAPTON or Poly imide. The conformal coating material used is humiseal 2A64. The boards are cleaned, measuring less than 4 microgram Nacl per sq in. against acceptabl
Electronics Forum | Wed Dec 20 07:54:13 EST 2006 | davef
We pipe a nonfunctional witness mark on every board. We inspect the witness mark. Ours consists of six pairs of dots arranged in a five-pointed star pattern. Again, consider paying attention to the cause of the problem. Your machine is NOT operat
Electronics Forum | Tue May 15 09:01:41 EDT 2001 | davef
Stephan makes good points. While monitoring the temperature in the plant is good, it might be more appropriate to measure the temperature in the cabinet of your dispensor. A sure indicator of temperature change is process changes over time. Consid
Electronics Forum | Thu May 16 15:05:20 EDT 2002 | Hussman69
No need to make rocket science out it. Buy an AOI mchine. If that's too expensive, scrap a board to use as a sample. Can't do that, use a digital camera and snap a couple pix of a good board and make some kick ass work instructions to use. Can't
Electronics Forum | Fri Oct 04 11:34:42 EDT 2002 | Bob Willis
Some additional comments from a paper may be of interest. Baking Printed Circuit Boards - Why and How Baking printed boards prior to conventional and surface mount assembly should not be necessary. Often boards are baked for historical reasons; in
| 1 |
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411
