Electronics Forum | Fri Jun 24 04:42:12 EDT 2005 | ajaydoshi
We do have BTU 150 Paragon. What the practical air setting for all 10 zones + 2 coolig zone. This setting is to manually adjust on machine front right botton side. ajay
Electronics Forum | Mon Sep 20 20:43:19 EDT 2021 | ttheis
One of our GSM machines started having an issue with "spitting" parts onto the board / blowing them around. I determined the problem be that spindle #2 on our flex head is not touching the parts all the way down to the board. It is stopping just abov
Electronics Forum | Tue Jun 17 11:02:47 EDT 2008 | dwelch123
You need to adjust the air kiss. The machine blows a slight amount of air after placement and it is probably adjusted too high.
Electronics Forum | Fri Aug 06 13:46:20 EDT 2004 | Marcel
Dhanish, on a CP6 if you have skew problems or missing parts begin by a center check on your smalls nozzles. If all nozzles goods, you will have to check the Z zero of the table, this is the pulse count of the z axis (table height) when the turret is
Electronics Forum | Tue Feb 22 12:02:11 EST 2005 | siverts
The first thing to do, as always with any trouble shooting, is to try to isolate your problem area, then it is much easier to pinpoint and find a solution for the problem. Some simple checks you can do, besides the good suggestions you got from some
Electronics Forum | Tue Jul 05 16:29:27 EDT 2005 | stepheniii
The air kiss is to replace the vacuum with air so the part will drop off the nozzle. Every machine I've seen with Air kiss, uses it when discarding a part as well as when placing a part. The air kiss should not be strong enough to blow the nozzle off
Electronics Forum | Sat Apr 03 19:56:56 EST 1999 | M Cox
I now have the opportunity to work on the MVII's. And I have some questions Do the PCB's have to have tooling holes for the transport of Boards in and out of the machine? These machines are running like S___t. Lots of parts in the reject bin, and s
Electronics Forum | Tue Jul 19 06:17:20 EDT 2005 | Rob
Have you tried a smaller nozzle? I'm wondering if the air is escaping through the cut outs on the device on the air kiss stage.
Electronics Forum | Fri Jul 20 16:39:18 EDT 2007 | john_smith
Jacky, we have had a similar problem. We needed to go to a smaller nozzle and also check your vacuume system and air kiss.Could be after placement when the machine blows air to insure the part is off the nozzle that it is effecting the solder brick.
Electronics Forum | Mon Aug 01 17:54:02 EDT 2005 | Stefan
If you are using vib. feeders than the component may be flipped length wise by the following components. Components should be landing with the leads on the right side but upside down. If you are using tape feeders the component may be flipped sideway
