Electronics Forum | Mon Dec 17 12:06:58 EST 2007 | pjc
5 Steps to Eliminate Bridges: 1. Establish (wave) Parallelism First and foremost, you must establish board-to-wave parallelism. This is the prerequisite to any wave solder process control. For an understanding of the power of this approach go to ht
Electronics Forum | Mon May 07 11:59:48 EDT 2007 | realchunks
Just as I thought earlier, you have a stagnant wave. You should be able to mechanically adjust it so it flows in the same direction of your boards.
Electronics Forum | Mon May 07 10:27:40 EDT 2007 | colormaker
The spray bottle puts more flux on the board but I am not sure how to measure ? I just got the Novastar 12S and its very difficult to set up. When I fix one problem another one show up. When I do get good results I dont make changes and then after a
Electronics Forum | Mon May 07 22:28:17 EDT 2007 | colormaker
radiant heat. 137c The hollis was a great machine. The one I had the prehead wass on or off there was no setting. The pot temperature guage was brocken so I had to guess and manually turn the heater on and off. The whole machine was covered with 1 i
Electronics Forum | Mon May 07 11:09:49 EDT 2007 | davef
4 Fluxer Operation 4.1 Set-Up and Check-Out the Fluxer 4.1.1 Spray Fluxer Set-Up and Check-Out 4.1.1.1 Pass a sample unsoldered board through the machine. 4.1.1.2 Remove the board just after passing through the fluxer and the air knife. 4.1.1.3
Electronics Forum | Tue Feb 08 14:56:09 EST 2011 | rkr76
Hello everyone, I have a question regarding wavesoldering and measuring if a proces/machine is in control. I made a custom carrier for measuring contact time, parallelism, solder temperature, coveyorspeed and some data of the preheat section. The s
Electronics Forum | Tue Oct 11 14:02:59 EDT 2016 | mnorthey
We have a slider Bar on the back side of our Delta Wave. It is adjustable and slides up and down (adjusting bolt) on the back edge of the Lamda Wave to prevent this problem; keeping the trough behind the Lamda is essential as well. Along with attenti
Electronics Forum | Mon Sep 10 12:27:32 EDT 2007 | hakerem
Hi Dave - You are correct that I was not clear in my comments. I assumed Joris had seen the usual solder balls accompanying his blowholes. Nevertheless, Joris, my first two recommendations still stand. Increasing the dwell time of your leads in t
Electronics Forum | Sat May 17 09:42:10 EDT 2008 | realchunks
The Optimizer can be run through your wave like a regular board. It measures temps, times and parallelism of your waves in relationship to your board (pot to conveyor). Run the Optimizer till you get you temps, times and are parallel to your waves.
Electronics Forum | Sun May 09 06:34:53 EDT 2004 | alex
i want to know that friends what is the angle of conveyor in wave soldering machine to get good soldering , can we adjust angle
