Electronics Forum | Wed Oct 04 16:27:05 EDT 2006 | russ
real time chat window may be nice? May help with issues a bit quicker? Russ
Electronics Forum | Fri Sep 22 11:32:16 EDT 2006 | cyber_wolf
The ability to post pictures would be nice.
Electronics Forum | Fri Sep 29 16:30:19 EDT 2006 | realchunks
Sure thing, for you Loco.
Electronics Forum | Sun May 22 23:33:16 EDT 2005 | Thaqalain
An 8 bit transformer register has output voltage of LHLHLHLH,What will be the equivalent decimal # stored?
Electronics Forum | Mon Jul 11 16:07:27 EDT 2022 | madisreivik
You cannot use diamond cut routers on aluminium. They will clog up in seconds.. You have to use "endmill" type. These are available from all PCB drill/mill supplier, nothing fancy. Depaneling - you mean cutting only tabs, not full perimeter ?
Electronics Forum | Mon Jan 04 16:55:47 EST 2010 | dyoungquist
We use a HEPCO model 3000-2 (hepcoblue.com) to shorten leads on various through hole components before we solder them on a pcb. You will have to verify they have a die that works with your particular LED module. If they do, this is what I would rec
Electronics Forum | Sat Jul 23 01:51:04 EDT 2022 | poly
You'll find a lot of guides for cutting aluminium on the internet but basically, try and use a bigger end mill if you can, keep it at the right speed (not slower). We cut 1.6mm aluminium with a 3mm end mill. Smaller end mills didn't evacuate the chip
Electronics Forum | Mon Jan 04 15:40:31 EST 2010 | dilogic
We recently got a job where (after placing SMT parts) we have to solder LED dot-matrix 8x8 display modules manually on the pcb. Due to the PCB design, it has to be TH type (also, it's the only type available) and soldered manually (or using selective
Electronics Forum | Mon Sep 30 18:16:36 EDT 2019 | slthomas
I'm beginning to think that the screws "just aren't made like they used to be". That said, if the description of the bit is just PH0, PH00, "standard" or "high torque" without providing geometry (same thing goes for the screws), it's nearly impossi
.gif)
