Electronics Forum | Sat Dec 13 02:05:23 EST 2014 | pratkul
I want know What is the process of the ODU Control Box Assembly. specially after wave soldering process i need.any one can help.
Electronics Forum | Tue Jan 06 14:44:00 EST 2015 | gafur
hi...i have problem with my spi kohyoung machine..the software can't load other model after running production..No one knows with this issue ? thank's
Electronics Forum | Sat Jan 17 06:29:23 EST 2015 | buckcho
Hello, I have seen the machine doing this problem after being on bypass. Try closing and opening the program again. Maybe the program can have problems, try making it from the beginning. I hope you fixed your problem.
Electronics Forum | Mon Feb 09 08:34:50 EST 2015 | saoasasd
In my case most of the PCBs are OSP finishing and worst case of MSD component on bottom side is level 3 (168 hours). You mean that PCB shelf life with bottom side assembled shoud be 84 hours?
Electronics Forum | Mon Feb 09 10:51:10 EST 2015 | jax
If solderability is the only concern, then there is no standard time. Multiple factors involving OSP thickness, Flux activation levels, profile parameters, storage environment will drive the problem. You just need to perform tests to determine your m
Electronics Forum | Wed Mar 18 09:54:41 EDT 2015 | rgduval
My pleasure. My experience with Heller's tech support has always been top-notch. And, as one of the few capital equipment companies that will support after-market machines without excessive registration fees, I always recommend Heller machines. ..
Electronics Forum | Wed May 13 16:09:17 EDT 2015 | ttheis
After about 5 minutes of trying different code combinations I found it- hold simultaneously: F1 - Left - Down - Right FYI the setup menu pass code is: F2 - Left - Up - Down
Electronics Forum | Fri Jun 19 08:04:36 EDT 2015 | cgreiner
I have a Ekra system manual titled "XPRT 5 Inline automatic screen printer". If you think that this is what you are after, send me your email address and I will send it to you. Best Regards
Electronics Forum | Mon Aug 29 11:39:23 EDT 2016 | tdemon69
I was wondering if you could help me with my Panasonic MV. it is throwing parts around after it picks them up . only have 3 heads work in it.
Electronics Forum | Wed Jul 01 11:48:30 EDT 2015 | sssvajunas
We use component BFU730LX and we have one problem. After reflow transistor base or collector lands are not soldered. Maybe someone have similar problems with this component? We tryed to change stencil pads (smaller , bigger) but problem is the same.