Electronics Forum | Fri Nov 18 15:45:27 EST 2016 | jg_annaanthan
Hi all, my site using x-ray machine "Agilent 5DX Series 5". The tester will hang around 10- 15 min during perform automatic startup at level "Delta Z". My site, we already change Front & Rear laser, burn galil, performed manual startup, total shutdow
Electronics Forum | Tue Sep 04 14:48:56 EDT 2007 | kadelson
The end of support of the 5DX is only for the Series IIL system. The series 3 and Series 5000 are still supported. The support included Technical support and parts support.
Electronics Forum | Thu Jan 22 04:21:56 EST 2009 | aj
Hi all, We are currently evaluating the above mentioned Xray system. I would appreciate some feedback from users on good & bad points and maybe things to look out for. At this moment and time it is mainly 2series systems due to obvious reasons, bu
Electronics Forum | Tue Jul 31 20:55:36 EDT 2001 | davef
Just so that you know, the 5DX does laminography. Like the word lamination, laminography takes a series of short focal length xrays, each a little deeper than the previous. Microlaminography allows layer by layer information to be measured in 'slic
Electronics Forum | Thu Jul 31 18:46:58 EDT 2008 | jdd
We are in the process of determine our target. We are inspecting with all the options Presence, Joints, OCV, Polarity, etc. What would be an average of ppm on AOI? 1000, 5000, 10000? Low volume - High mix. our machines are Agilent SJ50 Series 3
| 1 |
