Electronics Forum | Wed Oct 11 09:23:06 EDT 2000 | Roger Squires
Has anyone had any success in finding open circuits (i.e. ball present but not soldered to PCB) under collapsible BGA's using an Agilent HP5DX x-ray tester and the BGA2 algorithm? Can anyone recommend an elongated pad design which produces the neces
Electronics Forum | Fri Apr 13 02:59:09 EDT 2007 | X-ray tester
5DX is good. Here some information for the Agilent 5DX machine -Automated X-ray Inspection- http://www.home.agilent.com/USeng/nav/-536900435.0/pc.html
Electronics Forum | Mon Feb 18 17:27:03 EST 2002 | hgwells
Agilent has a great article on determining whether automated optical inspection (AOI) or automated x-ray inspection (AXI) is right for you. It's a PDF file that can found here: http://www.ate.agilent.com/EMT/LIBRARY/X-RAY/DOCS/59883661en.pdf To sum
Electronics Forum | Tue Jun 11 06:43:28 EDT 2002 | pjc
If your goal is to inspect solder joints then X-ray is the way to go. AOI is not effective at solder joint and is best at component inspection. Using an AXI or AOI for solder joint inspection requires a lot of engineering time. Don't know any good si
Electronics Forum | Fri Dec 03 12:01:14 EST 2004 | mruzicka
AOI (automatic optical inspection) is not capable to detect hidden joints (BGA, J-leads,...) defects. For that you will need X-Ray (AXI = Automated X-ray Inspection). Look @ http://www.agilent.com, they have both systems. It is usual that PWB manufac
Electronics Forum | Wed Aug 30 07:34:23 EDT 2006 | Xray Tester
For Automated x-ray inpsection system comes in 2D and 3D. 2D also know as the transmission xray inspection where xray are generated from a fixed point source. On double side board, this does not work that well. That where 3D Automated x-ray inpsectio
Electronics Forum | Mon Feb 09 15:24:45 EST 2009 | devgru
We looked at the 5DX as well, but it was way too cost prohibitive at the time and ended up purchasing the Yestech stand alone x-ray system. At the time Yestech did not have a comparable system to the 5DX, but I understand they do now. With Agilent
Electronics Forum | Fri Nov 18 15:45:27 EST 2016 | jg_annaanthan
Hi all, my site using x-ray machine "Agilent 5DX Series 5". The tester will hang around 10- 15 min during perform automatic startup at level "Delta Z". My site, we already change Front & Rear laser, burn galil, performed manual startup, total shutdow
Electronics Forum | Wed Aug 04 09:49:58 EDT 2004 | davef
We know of no such service provider in Malaysia. Consider contacting major xray equipment suppliers [eg, Glenbrook. V.J. ElectroniX, Agilent, Teradyne, etc] to determine: * Service suppliers in your region. * Terms that they offer in providing xray
Electronics Forum | Wed Oct 08 11:01:07 EDT 2008 | ck_the_flip
NEITHER AXI nor AOI are "stable" or "repeatable." If your false call rate is zero, then you've basically rendered the machine an expensive conveyor (ie it's passing everything 'cause you've opened the limits too much). You can *try* to do a Cpk or
.gif)
winsouce.jpg)