Electronics Forum | Fri Oct 01 00:49:33 EDT 2010 | darrenj
Yes, we have the Agilis stick feeder and it is a definite improvement on the vibe. It usually comes with a set of starter 'tubeforks', but i bought another starter set after a while since the individual tubeforks are relatively expenisive. Always g
Electronics Forum | Fri Jan 13 09:48:27 EST 2017 | westshoredesign
10mins to print an 8mm wheel. Experimenting with both Ninja Flex, and Ninja Semi-Flex, I think the Flex is probably going to be the winner though. Had to upgrade our filament feeder on the printer to use either of them. Totally worth it though. Not s
Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Tue Jan 27 10:12:21 EST 2004 | ldavis
Has anyone completed time studies on Mydata's Agilis feeder system? Is the time to load / unload reels any faster than traditional feeders? Any comments regarding the Agilis feeders would be greatly appreciated.
Electronics Forum | Fri Mar 03 00:00:17 EST 2006 | John
Mydata sells clips you put on the cover tape after it is removed from the agilis feeder.
Electronics Forum | Wed Jan 28 08:24:33 EST 2004 | stefwitt
35 hits on the search result of this forum entering agilis in the search window. There is at least some user feedback.
Electronics Forum | Mon Feb 02 08:57:26 EST 2004 | pjc
Contact Mydata and they can give you a lengthly list of Agilis users to contact.
Electronics Forum | Mon Aug 01 08:54:39 EDT 2022 | spoiltforchoice
You should get good service support and reliability from all of them, provided your local distribution agent is a good one. In the UK for instance I would trust all 3 on that front but I would expect very different support pricing structures. Any ma
Electronics Forum | Fri Nov 04 21:57:37 EDT 2011 | machinehead
When I'm Tearing down a Job, And removing the tape and reel from Agilis Feeder. Their is a gap of at least 10-12 Parts. Unpicked parts, When the knife on the feeder spreads the tape aside. and leaves this gap of feel falling parts.
