Electronics Forum | Tue Feb 25 15:28:07 EST 2020 | SMTA-Alex
TPSys is the machine operating system, proprietary from Mydata (Mycronic, now). It's based on Linux. You have to purchase the upgrades from Mycronic. Depending on which version you're upgrading from, the cost might vary. If the machine you're buying
Electronics Forum | Thu Apr 27 23:42:36 EDT 2006 | ajca20
Well the first thing you should know is once Mydata comes out with a new version, the older one is done. We have upgraded to the 2.4.4 and it it was well worth it. We increased our speed because the Agilis LM magazines are faster. Mydata always adds
Electronics Forum | Thu Feb 27 15:14:53 EST 2020 | SMTA-Alex
This happens with either old tape, the cover tape doesn't stay sealed on the left side, or is the seal is too far to the right, the knife lifts the cover tape. There isn't much you can do in this case. Your choices are: switch the component into an A
Electronics Forum | Fri May 14 08:30:52 EDT 2004 | pjc
For any application- high-mix, low volume to low-mix high-volume: J.O.T. Automation board handling MPM UltraFlex 3000 printer CyberOptics SE300 3D post print inspector 2x Mydata Synergy II w/ Linear Magazines and Agilis feeders CyberOptics Flex
Electronics Forum | Mon Aug 01 08:54:39 EDT 2022 | spoiltforchoice
You should get good service support and reliability from all of them, provided your local distribution agent is a good one. In the UK for instance I would trust all 3 on that front but I would expect very different support pricing structures. Any ma
Electronics Forum | Wed Apr 26 14:06:46 EDT 2006 | mdm4ua
Hi JEM, We just made the very same upgrade you are looking to make on three machines. We purchased a new MY12 and upgraded our other three (My9 W/hydra, My9 No Hydra, and TP9-2U) from 2.2.4C to 2.4.4c. There are several changes and most of the
Electronics Forum | Wed Sep 21 12:30:03 EDT 2005 | Rob
Hi Greg, We've used lots of machines over the years & seen lots of different tape related issues - the main one being snap off of the cover tape, usually due to too much glue, over entusiastic heat seal, or a feeder requiring maintainance. Also the
Electronics Forum | Sat Jan 08 00:47:12 EST 2005 | Grant
Hi, Yes, one of the problems with the MYDATA is the feeders are in groups, but at the same time, they are simple, and don't break. But the new Agillis 12 and 16 mm feeders do jam a bit. It's worse on glued cover tape, while heat bonded cover tape is
| 1 |
winsouce.jpg)