Electronics Forum | Thu Jul 03 10:24:54 EDT 2008 | grayman
Hello WaveMaster Larry, I think you are very well knowledgeable in wave machine or process. However, I think the reason why your former company won�t listen to you is because you also never listen to your people. I think you overlooked the saying �N
Electronics Forum | Mon Jun 07 15:33:08 EDT 2010 | bderks
Hi, I'm working at a very small electronics assembly firm and we need to get a better thermal profile of our reflow and solder wave ovens. Our firm is part of a larger firm that was set up to help handicapped people find work in the Netherlands. Yo
Electronics Forum | Fri Jul 09 19:09:52 EDT 2010 | rway
A couple of things: Does the cap break if you try to remove it with hot air? If not, than you are breaking the caps do to mechanical stress. We have had similar issues. I don't think your board is suffering from mechanical stress from depaneling o
Electronics Forum | Sat Jun 04 12:11:49 EDT 2011 | davef
Q1) How to identify on good or bad RF shield that could contribute to dewetting? A1) We use Alloy 770 and 752 [German silver] for our RF shields. We have never seen a solderability issue, even aged stock solders well. * Nickel Alloy 752, Nickel Silv
Electronics Forum | Fri Jan 04 22:01:25 EST 2013 | bradlanger
Depending on the age of your machine you should be able to find an IDE hard drive that will work at an online computer parts store like Newegg.com or Tiger direct. There is a possibility on the older machines that the motherboard bios could limit th
Electronics Forum | Thu May 30 09:55:52 EDT 2013 | rgduval
I like AIM solder paste, personally. But, much like asking which pick and place machine is best on this board, you're likely to get as many opinions as there are paste manufacturers. I just took a look at Alpha's datasheet for this product, and it
Electronics Forum | Tue Apr 29 07:44:55 EDT 2014 | spoiltforchoice
Make sure you fully understand your own products requirements. How many components of each feeder type they will require? How many Feeder slots those feeders will require? How different each product is and how that will affect changeover times - whic
Electronics Forum | Thu May 18 23:36:46 EDT 2017 | neoply
Hello all. Thanks for taking up your time to read my post. In this age of questing for ever-more-efficient circuit designs, I have been presented with an anachronistic design problem: I need to keep a roughly constant load on a steam-powered turbine
Electronics Forum | Mon Mar 19 09:37:01 EDT 2018 | spoiltforchoice
Another critical part of a process with a large board is support. Most commonly this is a bed of pins e.g something like red-e-set but there are other solutions. Support with a large panel will be critical for printing to get a good gasket between PC
Electronics Forum | Fri Jun 02 13:47:06 EDT 2023 | tommy_magyar
The Tucano is easy to use, user friendly menu, easy debugging if there is a problem. The thing is, this one is ages old and had some problems previously which required a near to £10k investment (controller board replacement and some calibration) but
