Electronics Forum | Tue Oct 01 05:10:20 EDT 2013 | anilw2006
Please go to output from I/O option and press on/off option in the main conveyor. While on condition motor should on when off motor should stop.If this will not happen then need to change I/o card.
Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Mon Apr 10 15:47:47 EDT 2017 | jdengler
Mark, There is a way to read the I/O but without the electrical diagrams I cannot help you with that. When you press the interlock button does it go out? Jerry
Electronics Forum | Tue May 07 07:42:36 EDT 2002 | smtexpert
I have YAMAHA YVL80 Pick & Place machine which has consistent failures of head I/O card (CPU 8344) due to excessive heating of bridge rectifier on it. We have already replaced this card twice within span of just 3 months. Can I have some tips from an
Electronics Forum | Mon Oct 16 10:07:11 EDT 2006 | realchunks
Wow, 15 degrees C is too much. Is this a new problem or new oven? If it's a new problem several things you can check out. Thermocouple placement may have got knocked into the wrong spot, or it could be dirty. I've seen this happen after a PM and
Electronics Forum | Tue Mar 27 15:49:54 EDT 2012 | bradlanger
Try Re-seating the card that connects the ISA slot from the computer mother board to the I/O Dpram card. It may be worth checking the ISA card for bad solder joints. The computer mother board could be going bad. Check for vented electrolytic caps. Ho
Electronics Forum | Mon Apr 10 09:04:52 EDT 2017 | mrich208
The unit stopped sending air to the inserter suddenly. When I send the Status signal to the unit from the PC it returns waiting for NO Pushbutton/Limit. I can not find any issue with the limits or Em Stop buttons. Is there a chance that we lost an IO
Electronics Forum | Thu Oct 20 13:34:08 EDT 2011 | babe7362000
I checked the housing and it can move up and down freely. I went into Cal and also moved it without a problem. The sensors in the digital I/O seem to be fine. I checked the voltage going to the driver card and it seems to be fine. I think I will s
Electronics Forum | Wed Oct 02 00:35:33 EDT 2013 | sonavc
thanks I tested the conveyor A or B , when it is on the motor turn and the green LED at the out put card is also light on. But when i turn on the X y table motor , the green LED is on , but the motor is not run. I will try to replace the I/O
Electronics Forum | Wed Jan 14 22:19:18 EST 2004 | Dean
It's called VIOS. It can be run on a PC. But, it must be massaged considerabley as there is no I/O, servo or master cards in communication. Consult Assemblion for details. Remember, altering their software without express permission could put you i
