Electronics Forum | Wed Apr 30 07:03:07 EDT 2008 | gemengr
DEK_265LT had been turn off and on by itsefl couple of time yesterday,and then off for good. I check the power going in to machine to the switch,got power to it,then power out to that little green box but there wasn't any power out put from that lit
Electronics Forum | Wed Jul 20 18:08:38 EDT 2005 | russ
How long is it taking to reach the 150? We use the 020 here along with 023 and have very good results with our machine. The 023 is rated for a higher temp then the 020 but I don't know about staying power. We heat from both the bottom and the top
Electronics Forum | Fri Apr 26 15:00:44 EDT 2013 | leemeyer
This is what the manual says about this message : Power Failure Detected A main power failure occurred and the machine is being powered by the UPS. All heaters are shut off immediately ad the conveyor clears all boards If main power is not restored w
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Wed Apr 11 17:00:28 EDT 2012 | rodrigo
Hi all, Our cp4 moves rather violently (jerks) all axis when the reset sw is pressed after power up. I've got all sorts of errors after boot up: Servo amp error: D,X,Y, etc Overtravel D,X,Y, etc D clutch error, power off machine We've checked all
Electronics Forum | Tue Aug 05 12:05:20 EDT 2003 | dougt
It looks like I could setup a UPS on this machine one of two ways. The first would be a 3 phase, 208V UPS in series with the machine (sounds big and expensive). The second is a single phase 208V UPS to just the 2 computers. I have a safety concern
Electronics Forum | Mon Jan 31 12:24:24 EST 2000 | Dave F
Robert: Several points: 1 Dross is a mixture of various things with no "fixed" composition: � The obvious things are metal oxides mixed with metal and this can vary in color with temperature and composition - remember some intermetallic oxides form
Electronics Forum | Tue Apr 16 09:58:10 EDT 2019 | ttheis
Resolved; the power box "service" switch was set to ON. Changed to OFF and machine powered up per instructions. Didn't see this switch mentioned anywhere in the power up procedure. Thanks to the previous owner for tipping me off.
Electronics Forum | Tue May 29 20:09:50 EDT 2007 | stepheniii
http://michaelbluejay.com/electricity/cooling.html this page has it right about minimizing AC energy use. With the wave, look at two machines. One you turn off, the other you let idle. The one that is turned off is using no power. The other one is
Electronics Forum | Thu May 26 05:46:14 EDT 2005 | ajaydoshi
What is the exact error message? or error code? Machine stop ramdonly. No error code if try to reset error it show T , turn power off. then turn off power . start again. set cam angle manually to origion & start. thanks ajay
.gif)
