Electronics Forum | Tue Jul 09 07:35:48 EDT 2019 | stephendo
Watch the air pressure gauge and make sure you have a good steady air pressure. I don't know about the Rad 5 but the Rad 3 was sensitive to fluctuations in air pressure. By any chance do you have a VCD running nearby when you are having the problems?
Electronics Forum | Wed May 20 14:03:53 EDT 2020 | dwl
Buy a dryer to go with your compressor. Compressed air traps a lot of water and you don't want that in your air lines on your P&P machines. Additionally, make sure you keep up with all the preventative maintenance and change out the filters as requir
Electronics Forum | Thu Oct 08 16:42:05 EDT 2020 | babe7362000
Does anyone have Page 6 and 7 of the MPM SPM manual? I am currently having issues with low air pressure that pushes the table in. I get good air that pushes the table to the entrance, but I do not get good air pressure that pushes the table in. I
Electronics Forum | Wed Sep 20 17:06:23 EDT 2000 | jackofalltrades
On the Vitronics/Soltec Wave Soldering Machines, we have no problems with the hot air knife (called a "Select X De-Bridging Tool" by Vitronics). We have both Delta's and Delta Max's. We have used both air and nitrogen with no problems. When using a "
Electronics Forum | Thu Sep 21 12:03:35 EDT 2000 | Boca
We have been using a hot air knife on Electrovert equipment for a few years. It must be set up properly for a given machine, primarily the distance from the trailing edge of the wave. Sometimes the set up must be adjusted for the assembly being sol
Electronics Forum | Tue Apr 11 17:45:02 EDT 2000 | Ashok Dhawan
I am looking for an appropriate method to dry wave soldered boards. While board assemblies are passed through board cleaning station , they are not fully dry . We do not want to heat above 180 deg F to dry them completely. We think that air drying u
Electronics Forum | Thu Jan 20 15:11:26 EST 2000 | Russ
I tested out the OK unit and found it to be a "down and dirty" rework machine that will do BGAs if demeanding thermal requirements are not needed. My largest concern was the lack of bottom side preheat. I have recently purchased the Air-Vac DRS24 a
Electronics Forum | Fri Jul 05 23:51:34 EDT 2002 | fastek
Sold a customer a Conceptronics HVA-70 Convection Reflow Oven recently. While performing the install I asked if compressed air was hooked up. Seems this customer ...who already had a HVA-70 convection reflow oven never used air or nitrogen with that
Electronics Forum | Tue Oct 11 13:50:21 EDT 2005 | stepheniii
you take the stencil which is contaminated with basically a toxic substance, add a solvent (alcohol) then use compressed air to blast it all into the air you breathe. I used to use foam wipes that were pretty good. I've also seen thick clothe ones t
Electronics Forum | Fri Feb 29 08:27:34 EST 2008 | tbkonrad
This morning I turned on our Qsv-1 and ai resiveved the following error. "Clamp did not open: House Air pressure may be lower then 70 psi" after checking the Air Pressure it reads at 80 psi on the Main air pressure gauge as well as the 80 psi on the
.png)
