Electronics Forum | Sat Jun 28 22:52:34 EDT 2003 | ramanandkini
We have an Electromechanical assembly (clock) that has a step motor on the board. This electromechanical assembly is assembled in a screw less plastic moulded casing. The plastic casing is neither air tight nor water proof. The board is with SMOBC+ H
Electronics Forum | Mon Mar 30 16:02:44 EST 1998 | Michael Allen
| We have successfully put .016" vias in .030" pads. | There is no issue with .030" solder balls, since | the actual volume of the .002" via in pad is small | compared to the ball+solder paste volume. | We did notice random bubbles where, apparentl
Electronics Forum | Mon Mar 27 15:10:48 EST 2006 | ms
Hi Steve Thanks for your reply. Your comments make it sound like it may be the nature of this paste. Any one else agree? Paste control is fairly good. Paste is put in fridge straight after it arrives at inwards goods, (4deg). Removed from fridge
Electronics Forum | Wed Mar 25 16:38:21 EST 1998 | Steve Joy
We have successfully put .016" vias in .030" pads. There is no issue with .030" solder balls, since the actual volume of the .002" via in pad is small compared to the ball+solder paste volume. We did notice random bubbles where, apparently, the sol
Electronics Forum | Wed Mar 25 19:41:01 EST 1998 | Earl Moon
| We have successfully put .016" vias in .030" pads. | There is no drain off with .030" solder balls, since | the actual volume in the .002" depression is low. | We did notice random bubbles where, apparently, the | solder reflowed and trapped the a
Electronics Forum | Wed Mar 25 16:36:10 EST 1998 | Steve Joy
We have successfully put .016" vias in .030" pads. There is no drain off with .030" solder balls, since the actual volume in the .002" depression is low. We did notice random bubbles where, apparently, the solder reflowed and trapped the air in the
Electronics Forum | Thu Jan 31 15:13:20 EST 2008 | chef
You will need to develop your reflow profile which includes drilling a hole through the fab and into the ball for accurate temp measure. During profile/process development you will probably want 3D x-ray (consider contracting that out). Once in prod
Electronics Forum | Thu Jun 20 14:39:35 EDT 2002 | russ
I use TechSpray Wsol 2204-8SQ. This is a water soluble mask that is very thick and works pretty well for this application. Drying time depends on thickness and you should let it dry at least for a little while prior to running through the wave. Ea
.gif)