Electronics Forum | Fri Apr 27 09:41:44 EDT 2018 | cyber_wolf
Typically freezing and air conditioners equals a low charge.
Electronics Forum | Fri Apr 27 02:17:37 EDT 2018 | bukas
hello everyone, I have issue with one of my DEK air conditioners, it starts to freeze soon after we turn it on. most probable cause is low air flow or low refrigerant pressure. does anyone know what is operating refrigerant pressure range for DEK ai
Electronics Forum | Sat Mar 30 13:33:50 EDT 2019 | stephendo
This is not an HVAC unit. This is a small unit attached to a production machine to keep the solder paste from drying out prematurely or slumping. The volume of air being cooled and desicated would be less than 3 or 4 cubic meters.
Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster
Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It
Electronics Forum | Wed Aug 20 11:21:30 EDT 2003 | Stan Stacy
Our old roof mounted air conditioners are currently not working. We are having some very humid weather right now which has been giving us some solder paste contamination problems. My Surface Mount line is in one room, (approx. 19,000 sq. ft.) along w
Electronics Forum | Wed Nov 09 02:24:49 EST 2005 | laxman
Hi Dave, Normally in our country (India) during rainy season the temperature will be 25to 30 �C and RH of 50 to 60%. The reason behind this humidity issue is that recently we have moved to our new facility with centralised air conditioner with Chill
Electronics Forum | Thu Jun 04 17:32:20 EDT 2009 | bigdaddysoy9
If you are talking about assemblies, Class 1 is like cheap toys or something you wouldn't expect to last very long. Class 2 would be components for a television, air conditioner, automobile (except safety critical). Basically, things that you would b
Electronics Forum | Fri Oct 23 15:44:57 EDT 1998 | Mike
| We've got a continous flow cooling problem from our wave solder process into ICT. Our current configuration is a flatbelt conveyor into a manual de-pallet process, operator then places on to an edge conveyor. We've tried muffin fans, look good bu
Electronics Forum | Mon Jul 08 18:45:53 EDT 2019 | assuredtech
Would you happen to have the Jig used to check that the component itself is in spec with UIC's general specifications? 1.) Component in spec. 2.) Correct 2.5mm pusher on the feeder / dispense head. Also set the conditioner guide where the comp enter
Electronics Forum | Thu May 24 13:14:59 EDT 2007 | mfgengr
The answer is simple...kind of. The short answer in terms of total cost (if you don't run an air conditioner) is there is no difference. The technical answer is: The First Law of Thermodynamics - Conservation of Energy applies. You have an entire s
| 1 |
