Electronics Forum | Mon May 21 22:15:34 EDT 2007 | seb1970
Does anyone know where i can purchase a frame/stencil adapter for the MPM manual stenciler in Ohio? Preferably a air adapter. And also spare parts? Thank you for your help.
Electronics Forum | Wed Sep 26 11:42:19 EDT 2012 | comatose
I have an ap-25 and wish i had gotten the UP-2000 instead. How's that for an answer? The main difference is that the ap-25 uses linear motors and air bearings, whereas the up-2000 uses ball screws. The linear motors are faster, but the whole thing i
Electronics Forum | Tue May 07 07:31:15 EDT 2013 | davef
Pavel You're correct that you should consider the point loading of your placement, wave and other machines. I've put shops above the ground floor of buildings. Equipment suppliers are the best source of information about these requirements. BR, dav
Electronics Forum | Wed May 15 11:13:36 EDT 2013 | pavel_murtishev
Davef, Could you tell me if you filled your floor by additional concrete layer during your shop construction? Have you had any placement machines stability issues? Your input would be really valuable. Thank you.
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Mon May 06 05:32:39 EDT 2013 | pavel_murtishev
Jim, Thank you for the input. Could you please check your standard filter pore size? A model number would be valuable. How many shop volumes (in cubic meters) do you pump per hour? Customer is seriously thinking over installing AC system similar to
Electronics Forum | Mon May 06 21:40:40 EDT 2013 | davef
ANSI/J-STD-001: * Temperature and Humidity: 18-30°C, 30-70%RH ** If out of range, shall verify electrostatic discharge control program according to ANSI/ESD S20-20 is adequate. ** For process control, more restrictive temperature and humidity limits
Electronics Forum | Tue May 07 03:56:30 EDT 2013 | pavel_murtishev
Davef, Thank you. I wonder if you have ever faced with concrete layer thickness selection for SMT shops? All I have found refers to metal treatment shops (primarily milling & drilling). 6" concrete is thick enough for them to stabilize milling machi
Electronics Forum | Sat Mar 30 03:34:44 EDT 2019 | jacoblemaster
Are you still facing this issue? Well, I am so late to get to know this. I think you first check your evaporator coil if your air conditioner is still freezing up. It has been seen that a dirty airflow coil stops the proper flow of air through it. It
Electronics Forum | Tue Apr 30 05:05:16 EDT 2013 | pavel_murtishev
Colleagues, Now I am involved into plant ramp-up where 3x Panaconic NPM-W will be installed. New production hall is being designed right now and the problem is that constructors have never met SMT shops and know very few or next to nothing about requ