Electronics Forum | Thu Aug 26 12:55:44 EDT 2010 | fuji
My spec book shows 10 NL/min
Electronics Forum | Thu Aug 26 09:44:45 EDT 2010 | smtmfgeng
Hello all, I have a few CP43's and am struggling to find their air consumption ratings. I found that our IP3 consumes 240 Nl/min for the machine itself, and the MTU unit consumes 600 Nl/min, however Fuji's spec sheets do not list these ratings for t
Electronics Forum | Tue Aug 25 11:31:41 EDT 2020 | stephendo
yes Once I was using dewers of liquid N2 and recommended switching. I tried using air to the machine so the sensor would let the machine run. Boards went from good to a two inch icicle covering a large area. We went to a wall mounted single stage fi
Electronics Forum | Fri Sep 26 01:51:28 EDT 2008 | abhishek30781
i want to know all the deep details of fuji NXT II .for eg what is the features of NXTII ,specification,power consumption ,weight,height ,nozzle exchange while production option aviliable ,etc.
Electronics Forum | Tue May 09 02:18:45 EDT 2006 | Helmi
Hi, My company is using HEPA filter to improve air quality coming out of oven/wave solder. But the cost of such filter is quite high and we need to improve the consumption. Any suggestion from fellow experts out there? a. Anybody did a cost reduc
Electronics Forum | Thu Apr 24 12:45:41 EDT 2003 | cyber_wolf
Can someone possibly post a link, or get me the specs/requirements of an Omniflow 10 reflow oven ? Air consumption, power consumption, dimensions etc... Thanks
Electronics Forum | Thu May 21 06:15:46 EDT 2020 | bukas
everything Stephen said + it is really important that you have correct diameter pipes. If diameter is too small there will be a significant pressure drop in pipes (and machines have their consumption 100-500 NL - normal liters / min) and pipe system
Electronics Forum | Tue Jan 22 16:01:03 EST 2008 | jmelson
The P&P machine uses very modest power when idling. It draws burst of power when accelerating the gantry. So, the yearly power consumption is going to be a LOT less than nameplate figures. If it is largely air-driven, then you have to factor in th
Electronics Forum | Tue Jul 09 15:40:06 EDT 2019 | assuredtech
That's a great point about air consumption, don't reduce the 1/2 inch air line requirement, meet the CFM air requirement and of course dry shop air. Check the Auto oiler for the CTA is running correctly, 5W 30 NON Detergent oil only. Attached is a pi
Electronics Forum | Tue Jun 26 07:40:18 EDT 2001 | caldon
Try this link out. http://www.airliquide.com/us/ep&a/TechPapers.htm Air Liquide has done many studies on this topic. There should be some useful information there. Cal Caldon W. Driscoll ACI USA 610-362-1200 cdriscoll@aciusa.org