Electronics Forum | Tue Oct 11 13:25:41 EDT 2005 | Sean Jiam
Hi, We just purchased the above two machines and they're still in the trial period. We have problems with air requirements of the above two machines. For example, Samsung CP45 is listed at 8 CFM only, but it will kick off the compressor (rated at
Electronics Forum | Mon Dec 18 14:11:02 EST 2023 | erikfriesen
Has anyone ever replaced the venturi vaccum pump on the CP45 or other series machine? Or used a centralized vaccum system? It works fine, but air consumption seems excessive. This is what is in there, it probably uses 10cfm at least. https://www.p
Electronics Forum | Mon Jan 29 13:06:48 EST 2024 | erikfriesen
A follow up, using an external vacuum pump works fine, and reduces load on the air compresssor, probably using 1/3 of the air.
Electronics Forum | Tue Oct 22 20:32:16 EDT 2024 | jamesatqkits
I also use a small vacuum pump, this allows me to run a small compressor to supply air to the machine, around 7.5cfm. Someone suggested it to me years ago, the venturi system in the machine uses a lot of air and is noisy. The pump is a yellow jacket
Electronics Forum | Tue May 25 18:43:48 EDT 2021 | jamesatqkits
Air flow was the issue, more CFM required then my compressor an deliver. I have to use 2 compressors, you can hear a set of contacts engage when pressure is applied and sufficient.
Electronics Forum | Fri May 21 17:41:01 EDT 2021 | jamesatqkits
Hello, This is my first time posting to this forum, or forums in general, so go easy on me. I have just acquired a CP45FV NEO, "My other car is a CP45FV NEO" anyways, when I try to put the machine into ready mode I get the error, [0006] I/O power
Electronics Forum | Fri Mar 06 02:25:08 EST 2020 | bukas
it is not that big deal. you can use almost any generic grease. I use SKF bearing grease on CP45FV's. Just make sure you remove old grease, I use IPA and compressed air to do this. And don't put too much of it or too little. After greasing everything
Electronics Forum | Tue May 25 18:49:30 EDT 2021 | bukas
you need constant 4-6 bar pressure and 200 N liters of air if I remember correctly. dont forget to run calibrations. default system password is 1 after each head calibration you need to update machine in calibration menu and menu before that or it
Electronics Forum | Tue Oct 11 15:21:12 EDT 2005 | Hoss
Sean, If the machines use more than the spec'd 8CFM, are not leaking and work fine otherwise, I wouldn't disqualify them on that basis alone. You may be exceeding the duty cycle rating of your compressor and not necessarily the volume. If Samsung
Electronics Forum | Tue Oct 11 18:35:59 EDT 2005 | stepheniii
How big a tank do you have at the compressor? Basically the bigger the better. You will still have the same duty cycle ratio but the compressor won't be cycling as fast. Hopefully someone here knows what a good size would be. And when you say "kic
